projects / people / ms / u-boot.git / blame
| Commit | Line | Data |
|---|---|---|
| e9dfa1e1 JT |
1 | How to use U-Boot on Engicam Is.IoT MX6UL Starter Kit: |
| 2 | ----------------------------------------------------- | |
| 3 | ||
| 4 | - Configure U-Boot for Engicam Is.IoT MX6UL | |
| 5 | ||
| 6 | $ make mrproper | |
| 7 | $ make imx6ul_isiot_mmc_defconfig | |
| 8 | $ make | |
| 9 | ||
| 10 | This will generate the SPL image called SPL and the u-boot-dtb.img. | |
| 11 | ||
| 12 | - Flash the SPL image into the micro SD card: | |
| 13 | ||
| 14 | sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync | |
| 15 | ||
| 16 | - Flash the u-boot-dtb.img image into the micro SD card: | |
| 17 | ||
| 18 | sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync | |
| 19 | ||
| 20 | - Jumper settings: | |
| 21 | ||
| 22 | MMC Boot: JM3 Closed | |
| 23 | ||
| 24 | - Connect the Serial cable between the Starter Kit and the PC for the console. | |
| 25 | (J28 is the Linux Serial console connector) | |
| 26 | ||
| 27 | - Insert the micro SD card in the board, power it up and U-Boot messages should | |
| 28 | come up. |