common: Move CONFIG_BOOTARGS to Kconfig

[people/ms/u-boot.git] / include / configs / MPC8536DS.h

diff --git a/include/configs/MPC8536DS.h b/include/configs/MPC8536DS.h
index 0f29863a9678a81b21b8ddeeb4fa41fce118c9d7..da127d126fef60df64876a42dba83acabe28257d 100644 (file)
--- a/include/configs/MPC8536DS.h
+++ b/include/configs/MPC8536DS.h
@@ -37,13 +37,6 @@
 #define CONFIG_SYS_MONITOR_BASE        CONFIG_SYS_TEXT_BASE    /* start of monitor */
 #endif
 
-/* High Level Configuration Options */
-#define CONFIG_BOOKE           1       /* BOOKE */
-#define CONFIG_E500            1       /* BOOKE e500 family */
-#define CONFIG_MPC8536         1
-#define CONFIG_MPC8536DS       1
-
-#define CONFIG_FSL_ELBC                1       /* Has Enhanced localbus controller */
 #define CONFIG_PCI1            1       /* Enable PCI controller 1 */
 #define CONFIG_PCIE1           1       /* PCIE controller 1 (slot 1) */
 #define CONFIG_PCIE2           1       /* PCIE controller 2 (slot 2) */
@@ -53,7 +46,6 @@
 #define CONFIG_FSL_PCIE_RESET  1       /* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT   1       /* enable 64-bit PCI resources */
 
-#define CONFIG_FSL_LAW         1       /* Use common FSL init code */
 
 #define CONFIG_TSEC_ENET               /* tsec ethernet support */
 #define CONFIG_ENV_OVERWRITE
@@ -68,8 +60,6 @@
 #define CONFIG_L2_CACHE                        /* toggle L2 cache */
 #define CONFIG_BTB                     /* toggle branch predition */
 
-#define CONFIG_BOARD_EARLY_INIT_F      1       /* Call board_pre_init */
-
 #define CONFIG_ENABLE_36BIT_PHYS       1
 
 #ifdef CONFIG_PHYS_64BIT
@@ -102,7 +92,6 @@
 
 /* DDR Setup */
 #define CONFIG_VERY_BIG_RAM
-#define CONFIG_SYS_FSL_DDR2
 #undef CONFIG_FSL_DDR_INTERACTIVE
 #define CONFIG_SPD_EEPROM              /* Use SPD EEPROM for DDR setup */
 #define CONFIG_DDR_SPD
@@ -113,7 +102,6 @@
 #define CONFIG_SYS_DDR_SDRAM_BASE      0x00000000
 #define CONFIG_SYS_SDRAM_BASE          CONFIG_SYS_DDR_SDRAM_BASE
 
-#define CONFIG_NUM_DDR_CONTROLLERS     1
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   2
 
@@ -298,7 +286,6 @@
                                CONFIG_SYS_NAND_BASE + 0x80000, \
                                CONFIG_SYS_NAND_BASE + 0xC0000}
 #define CONFIG_SYS_MAX_NAND_DEVICE     4
-#define CONFIG_CMD_NAND                1
 #define CONFIG_NAND_FSL_ELBC   1
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (128 * 1024)
 
@@ -534,8 +521,6 @@
 
 #ifdef CONFIG_FSL_SATA
 #define CONFIG_LBA48
-#define CONFIG_CMD_SATA
-#define CONFIG_DOS_PARTITION
 #endif
 
 #if defined(CONFIG_TSEC_ENET)
@@ -561,8 +546,6 @@
 
 #define CONFIG_ETHPRIME                "eTSEC1"
 
-#define CONFIG_PHY_GIGE                1       /* Include GbE speed/duplex detection */
-
 #endif /* CONFIG_TSEC_ENET */
 
 /*
@@ -571,7 +554,6 @@
 
 #if defined(CONFIG_SYS_RAMBOOT)
 #if defined(CONFIG_RAMBOOT_SPIFLASH)
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SPI_BUS     0
 #define CONFIG_ENV_SPI_CS      0
 #define CONFIG_ENV_SPI_MAX_HZ  10000000
@@ -580,17 +562,14 @@
 #define CONFIG_ENV_OFFSET      0xF0000
 #define CONFIG_ENV_SECT_SIZE   0x10000
 #elif defined(CONFIG_RAMBOOT_SDCARD)
-#define CONFIG_ENV_IS_IN_MMC
 #define CONFIG_FSL_FIXED_MMC_LOCATION
 #define CONFIG_ENV_SIZE                0x2000
 #define CONFIG_SYS_MMC_ENV_DEV  0
 #else
-       #define CONFIG_ENV_IS_NOWHERE   1       /* Store ENV in memory only */
        #define CONFIG_ENV_ADDR         (CONFIG_SYS_MONITOR_BASE - 0x1000)
        #define CONFIG_ENV_SIZE         0x2000
 #endif
 #else
-       #define CONFIG_ENV_IS_IN_FLASH  1
        #define CONFIG_ENV_ADDR (CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE)
        #define CONFIG_ENV_SIZE         0x2000
        #define CONFIG_ENV_SECT_SIZE    0x20000 /* 128K (one sector) */
@@ -599,25 +578,11 @@
 #define CONFIG_LOADS_ECHO      1       /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   1       /* allow baudrate change */
 
-/*
- * Command line configuration.
- */
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_REGINFO
-
-#if defined(CONFIG_PCI)
-#define CONFIG_CMD_PCI
-#endif
-
 #undef CONFIG_WATCHDOG                 /* watchdog disabled */
 
-#define CONFIG_MMC     1
-
 #ifdef CONFIG_MMC
 #define CONFIG_FSL_ESDHC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
-#define CONFIG_GENERIC_MMC
 #endif
 
 /*
@@ -625,18 +590,12 @@
  */
 #define CONFIG_HAS_FSL_MPH_USB
 #ifdef CONFIG_HAS_FSL_MPH_USB
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #endif
 #endif
 
-#if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI)
-#define CONFIG_DOS_PARTITION
-#endif
-
 /*
  * Miscellaneous configurable options
  */
@@ -692,10 +651,6 @@
 /* default location for tftp and bootm */
 #define CONFIG_LOADADDR                1000000
 
-#undef  CONFIG_BOOTARGS                /* the boot command will set bootargs */
-
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
 "netdev=eth0\0"                                                \
 "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"                    \