include/configs: drop default definitions of CONFIG_SYS_MAXARGS

[people/ms/u-boot.git] / include / configs / P1022DS.h

diff --git a/include/configs/P1022DS.h b/include/configs/P1022DS.h
index 505b4178a40de2929d34da5e492d88419ddca96a..f7d43335df0f345a5452b5686745c558e367504f 100644 (file)
--- a/include/configs/P1022DS.h
+++ b/include/configs/P1022DS.h
@@ -96,7 +96,6 @@
 #define CONFIG_RESET_VECTOR_ADDRESS    0xeffffffc
 #endif
 
-#define CONFIG_FSL_ELBC                        /* Has Enhanced localbus controller */
 #define CONFIG_PCIE1                   /* PCIE controller 1 (slot 1) */
 #define CONFIG_PCIE2                   /* PCIE controller 2 (slot 2) */
 #define CONFIG_PCIE3                   /* PCIE controller 3 (ULI bridge) */
@@ -246,7 +245,6 @@
 
 #define CONFIG_SYS_NAND_BASE_LIST      {CONFIG_SYS_NAND_BASE}
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_CMD_NAND                        1
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (256 * 1024)
 #define CONFIG_ELBC_NAND_SPL_STATIC_PGSIZE
 
@@ -274,7 +272,6 @@
 
 #endif /* CONFIG_NAND_FSL_ELBC */
 
-#define CONFIG_BOARD_EARLY_INIT_F
 #define CONFIG_BOARD_EARLY_INIT_R
 #define CONFIG_MISC_INIT_R
 #define CONFIG_HWCONFIG
@@ -367,7 +364,6 @@
 
 #ifdef CONFIG_FSL_DIU_FB
 #define CONFIG_SYS_DIU_ADDR    (CONFIG_SYS_CCSRBAR + 0x10000)
-#define CONFIG_CMD_BMP
 #define CONFIG_VIDEO_LOGO
 #define CONFIG_VIDEO_BMP_LOGO
 #define CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS
@@ -500,20 +496,13 @@
 
 #ifdef CONFIG_FSL_SATA
 #define CONFIG_LBA48
-#define CONFIG_CMD_SATA
-#define CONFIG_DOS_PARTITION
 #endif
 
 #ifdef CONFIG_MMC
 #define CONFIG_FSL_ESDHC
-#define CONFIG_GENERIC_MMC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #endif
 
-#if defined(CONFIG_MMC) || defined(CONFIG_USB_EHCI)
-#define CONFIG_DOS_PARTITION
-#endif
-
 #define CONFIG_TSEC_ENET
 #ifdef CONFIG_TSEC_ENET
 
@@ -535,8 +524,6 @@
 #define TSEC2_PHYIDX           0
 
 #define CONFIG_ETHPRIME                "eTSEC1"
-
-#define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
 #endif
 
 /*
@@ -544,7 +531,6 @@
  */
 #define CONFIG_MTD_DEVICE
 #define CONFIG_MTD_PARTITIONS
-#define CONFIG_CMD_MTDPARTS
 #define CONFIG_FLASH_CFI_MTD
 #ifdef CONFIG_PHYS_64BIT
 #define MTDIDS_DEFAULT "nor0=fe8000000.nor"
@@ -562,7 +548,6 @@
  * Environment
  */
 #ifdef CONFIG_SPIFLASH
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SPI_BUS     0
 #define CONFIG_ENV_SPI_CS      0
 #define CONFIG_ENV_SPI_MAX_HZ  10000000
@@ -571,7 +556,6 @@
 #define CONFIG_ENV_OFFSET      0x100000        /* 1MB */
 #define CONFIG_ENV_SECT_SIZE   0x10000
 #elif defined(CONFIG_SDCARD)
-#define CONFIG_ENV_IS_IN_MMC
 #define CONFIG_FSL_FIXED_MMC_LOCATION
 #define CONFIG_ENV_SIZE                0x2000
 #define CONFIG_SYS_MMC_ENV_DEV 0
@@ -582,15 +566,12 @@
 #else
 #define CONFIG_ENV_SIZE                CONFIG_SYS_NAND_BLOCK_SIZE
 #endif
-#define CONFIG_ENV_IS_IN_NAND
 #define CONFIG_ENV_OFFSET      (1024 * 1024)
 #define CONFIG_ENV_RANGE       (3 * CONFIG_ENV_SIZE)
 #elif defined(CONFIG_SYS_RAMBOOT)
-#define CONFIG_ENV_IS_NOWHERE  /* Store ENV in memory only */
 #define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE - 0x1000)
 #define CONFIG_ENV_SIZE                0x2000
 #else
-#define CONFIG_ENV_IS_IN_FLASH
 #define CONFIG_ENV_ADDR        (CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE)
 #define CONFIG_ENV_SIZE                0x2000
 #define CONFIG_ENV_SECT_SIZE   0x20000 /* 128K (one sector) */
@@ -599,25 +580,12 @@
 #define CONFIG_LOADS_ECHO
 #define CONFIG_SYS_LOADS_BAUD_CHANGE
 
-/*
- * Command line configuration.
- */
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_REGINFO
-
-#ifdef CONFIG_PCI
-#define CONFIG_CMD_PCI
-#endif
-
 /*
  * USB
  */
 #define CONFIG_HAS_FSL_DR_USB
 #ifdef CONFIG_HAS_FSL_DR_USB
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #define CONFIG_USB_EHCI_FSL
 #endif
@@ -630,14 +598,6 @@
 #define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
 #define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
-#ifdef CONFIG_CMD_KGDB
-#define CONFIG_SYS_CBSIZE      1024            /* Console I/O Buffer Size */
-#else
-#define CONFIG_SYS_CBSIZE      256             /* Console I/O Buffer Size */
-#endif
-/* Print Buffer Size */
-#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
-#define CONFIG_SYS_MAXARGS     16
 #define CONFIG_SYS_BARGSIZE    CONFIG_SYS_CBSIZE
 
 /*
@@ -663,9 +623,6 @@
 
 #define CONFIG_LOADADDR                1000000
 
-
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "netdev=eth0\0"                                         \
        "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"             \