include/configs: drop default definitions of CONFIG_SYS_PBSIZE

[people/ms/u-boot.git] / include / configs / T104xRDB.h

diff --git a/include/configs/T104xRDB.h b/include/configs/T104xRDB.h
index 82d3f102e55411966d5c44b3ca3461f9f04ccbd0..5711c5235542f8f07ecef2bacd9fe325716eae1e 100644 (file)
--- a/include/configs/T104xRDB.h
+++ b/include/configs/T104xRDB.h
@@ -31,7 +31,6 @@
 #define CONFIG_SPL_SKIP_RELOCATE
 #define CONFIG_SPL_COMMON_INIT_DDR
 #define CONFIG_SYS_CCSR_DO_NOT_RELOCATE
-#define CONFIG_SYS_NO_FLASH
 #endif
 #define RESET_VECTOR_OFFSET            0x27FFC
 #define BOOT_PAGE_OFFSET               0x27000
@@ -162,8 +161,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 
 #define CONFIG_SYS_FSL_CPC             /* Corenet Platform Cache */
 #define CONFIG_SYS_NUM_CPC             CONFIG_SYS_NUM_DDR_CTLRS
-#define CONFIG_FSL_IFC                 /* Enable IFC Support */
-#define CONFIG_FSL_CAAM                        /* Enable SEC/CAAM */
 #define CONFIG_PCI_INDIRECT_BRIDGE
 #define CONFIG_PCIE1                   /* PCIE controller 1 */
 #define CONFIG_PCIE2                   /* PCIE controller 2 */
@@ -175,7 +172,7 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 
 #define CONFIG_ENV_OVERWRITE
 
-#ifndef CONFIG_SYS_NO_FLASH
+#ifdef CONFIG_MTD_NOR_FLASH
 #define CONFIG_FLASH_CFI_DRIVER
 #define CONFIG_SYS_FLASH_CFI
 #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE
@@ -183,13 +180,11 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 
 #if defined(CONFIG_SPIFLASH)
 #define CONFIG_SYS_EXTRA_ENV_RELOC
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SIZE                 0x2000          /* 8KB */
 #define CONFIG_ENV_OFFSET               0x100000        /* 1MB */
 #define CONFIG_ENV_SECT_SIZE            0x10000
 #elif defined(CONFIG_SDCARD)
 #define CONFIG_SYS_EXTRA_ENV_RELOC
-#define CONFIG_ENV_IS_IN_MMC
 #define CONFIG_SYS_MMC_ENV_DEV          0
 #define CONFIG_ENV_SIZE                        0x2000
 #define CONFIG_ENV_OFFSET              (512 * 0x800)
@@ -199,11 +194,9 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 #define CONFIG_BOOTSCRIPT_COPY_RAM
 #endif
 #define CONFIG_SYS_EXTRA_ENV_RELOC
-#define CONFIG_ENV_IS_IN_NAND
 #define CONFIG_ENV_SIZE                        0x2000
 #define CONFIG_ENV_OFFSET              (3 * CONFIG_SYS_NAND_BLOCK_SIZE)
 #else
-#define CONFIG_ENV_IS_IN_FLASH
 #define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE - CONFIG_ENV_SECT_SIZE)
 #define CONFIG_ENV_SIZE                0x2000
 #define CONFIG_ENV_SECT_SIZE   0x20000 /* 128K (one sector) */
@@ -404,7 +397,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 #define CONFIG_SYS_NAND_DDR_LAW                11
 #define CONFIG_SYS_NAND_BASE_LIST      { CONFIG_SYS_NAND_BASE }
 #define CONFIG_SYS_MAX_NAND_DEVICE     1
-#define CONFIG_CMD_NAND
 
 #define CONFIG_SYS_NAND_BLOCK_SIZE     (512 * 1024)
 
@@ -508,7 +500,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 #ifdef CONFIG_FSL_DIU_FB
 #define CONFIG_FSL_DIU_CH7301
 #define CONFIG_SYS_DIU_ADDR    (CONFIG_SYS_CCSRBAR + 0x180000)
-#define CONFIG_CMD_BMP
 #define CONFIG_VIDEO_LOGO
 #define CONFIG_VIDEO_BMP_LOGO
 #endif
@@ -632,7 +623,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 #define CONFIG_SYS_SATA1_FLAGS         FLAGS_DMA
 
 #define CONFIG_LBA48
-#define CONFIG_CMD_SATA
 #endif
 
 /*
@@ -641,9 +631,7 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 #define CONFIG_HAS_FSL_DR_USB
 
 #ifdef CONFIG_HAS_FSL_DR_USB
-#define CONFIG_USB_EHCI
-
-#ifdef CONFIG_USB_EHCI
+#ifdef CONFIG_USB_EHCI_HCD
 #define CONFIG_USB_EHCI_FSL
 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
 #endif
@@ -754,7 +742,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 /* Enable VSC9953 L2 Switch driver on T1040 SoC */
 #if defined(CONFIG_TARGET_T1040RDB) || defined(CONFIG_TARGET_T1040D4RDB)
 #define CONFIG_VSC9953
-#define CONFIG_CMD_ETHSW
 #ifdef CONFIG_TARGET_T1040RDB
 #define CONFIG_SYS_FM1_QSGMII11_PHY_ADDR       0x04
 #define CONFIG_SYS_FM1_QSGMII21_PHY_ADDR       0x08
@@ -766,7 +753,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 
 #define CONFIG_MII             /* MII PHY management */
 #define CONFIG_ETHPRIME                "FM1@DTSEC4"
-#define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
 #endif
 
 /*
@@ -775,26 +761,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 #define CONFIG_LOADS_ECHO              /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   /* allow baudrate change */
 
-/*
- * Command line configuration.
- */
-#ifdef CONFIG_TARGET_T1042RDB_PI
-#define CONFIG_CMD_DATE
-#endif
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_REGINFO
-
-#ifdef CONFIG_PCI
-#define CONFIG_CMD_PCI
-#endif
-
-/* Hash command with SHA acceleration supported in hardware */
-#ifdef CONFIG_FSL_CAAM
-#define CONFIG_CMD_HASH
-#define CONFIG_SHA_HW_ACCEL
-#endif
-
 /*
  * Miscellaneous configurable options
  */
@@ -802,12 +768,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 #define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
 #define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
-#ifdef CONFIG_CMD_KGDB
-#define CONFIG_SYS_CBSIZE      1024            /* Console I/O Buffer Size */
-#else
-#define CONFIG_SYS_CBSIZE      256             /* Console I/O Buffer Size */
-#endif
-#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16)
 #define CONFIG_SYS_MAXARGS     16              /* max number of command args */
 #define CONFIG_SYS_BARGSIZE    CONFIG_SYS_CBSIZE/* Boot Argument Buffer Size */
 
@@ -826,10 +786,9 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 /*
  * Dynamic MTD Partition support with mtdparts
  */
-#ifndef CONFIG_SYS_NO_FLASH
+#ifdef CONFIG_MTD_NOR_FLASH
 #define CONFIG_MTD_DEVICE
 #define CONFIG_MTD_PARTITIONS
-#define CONFIG_CMD_MTDPARTS
 #define CONFIG_FLASH_CFI_MTD
 #define MTDIDS_DEFAULT "nor0=fe8000000.nor,nand0=fff800000.flash," \
                        "spi0=spife110000.0"
@@ -850,9 +809,6 @@ $(SRCTREE)/board/freescale/t104xrdb/t1042d4_sd_rcw.cfg
 /* default location for tftp and bootm */
 #define CONFIG_LOADADDR                1000000
 
-
-#define CONFIG_BAUDRATE        115200
-
 #define __USB_PHY_TYPE utmi
 #define RAMDISKFILE    "t104xrdb/ramdisk.uboot"