projects / people / ms / u-boot.git / blame
| Commit | Line | Data |
|---|---|---|
| 5bdf6b57 | 1 | How to use U-Boot on Engicam i.CoreM6 Solo/DualLite and Quad/Dual Starter Kit: |
| f4b7532f JT |
2 | ----------------------------------------------------------------------------- |
| 3 | ||
| f4b7532f | 4 | $ make mrproper |
| 5c0d38f6 | 5 | |
| cc65e354 JT |
6 | - Configure U-Boot for Engicam i.CoreM6 Quad/Dual/Solo/DualLite: |
| 7 | $ make imx6qdl_icore_mmc_defconfig | |
| 5c0d38f6 | 8 | |
| 5bdf6b57 JT |
9 | - Build U-Boot |
| 10 | $ make | |
| 5c0d38f6 | 11 | |
| e88edc7b | 12 | This will generate the SPL image called SPL and the u-boot-dtb.img. |
| f4b7532f JT |
13 | |
| 14 | - Flash the SPL image into the micro SD card: | |
| 15 | ||
| 16 | sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync | |
| 17 | ||
| e88edc7b | 18 | - Flash the u-boot-dtb.img image into the micro SD card: |
| f4b7532f | 19 | |
| e88edc7b | 20 | sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync |
| f4b7532f JT |
21 | |
| 22 | - Jumper settings: | |
| 23 | ||
| 24 | MMC Boot: JM3 Closed | |
| 25 | ||
| 26 | - Connect the Serial cable between the Starter Kit and the PC for the console. | |
| 27 | (J28 is the Linux Serial console connector) | |
| 28 | ||
| 29 | - Insert the micro SD card in the board, power it up and U-Boot messages should | |
| 30 | come up. |