i.MX6: engicam: Add imx6q/imx6ul boards for existing boards

[people/ms/u-boot.git] / board / engicam / icorem6 / README

diff --git a/board/engicam/icorem6/README b/board/engicam/icorem6/README
deleted file mode 100644 (file)
index 3779e96..0000000
--- a/board/engicam/icorem6/README
+++ /dev/null
@@ -1,30 +0,0 @@
-How to use U-Boot on Engicam i.CoreM6 Solo/DualLite and Quad/Dual Starter Kit:
------------------------------------------------------------------------------
-
-$ make mrproper
-
-- Configure U-Boot for Engicam i.CoreM6 Quad/Dual/Solo/DualLite:
-$ make imx6qdl_icore_mmc_defconfig
-
-- Build U-Boot
-$ make
-
-This will generate the SPL image called SPL and the u-boot-dtb.img.
-
-- Flash the SPL image into the micro SD card:
-
-sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
-
-- Flash the u-boot-dtb.img image into the micro SD card:
-
-sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
-
-- Jumper settings:
-
-MMC Boot: JM3 Closed
-
-- Connect the Serial cable between the Starter Kit and the PC for the console.
-(J28 is the Linux Serial console connector)
-
-- Insert the micro SD card in the board, power it up and U-Boot messages should
-come up.