powerpc, 5xxx, 512x: remove support for mpc5xxx and mpc512x

[people/ms/u-boot.git] / post / board / pdm360ng / coproc_com.c

diff --git a/post/board/pdm360ng/coproc_com.c b/post/board/pdm360ng/coproc_com.c
deleted file mode 100644 (file)
index e11b69b..0000000
--- a/post/board/pdm360ng/coproc_com.c
+++ /dev/null
@@ -1,78 +0,0 @@
-/*
- * (C) Copyright 2010 DENX Software Engineering,
- * Anatolij Gustschin, agust@denx.de.
- *
- * SPDX-License-Identifier:    GPL-2.0+
- */
-
-/*
- * Co-Processor communication POST
- */
-#include <common.h>
-#include <post.h>
-#include <serial.h>
-
-/*
- * Actually the termination sequence of the coprocessor
- * commands is "\r\n" (CR LF), but here we use a side effect of
- * the putc() routine of the serial driver which checks for LF
- * and sends CR before sending LF. Therefore the termination
- * sequence in the command below is only "\n".
- * "alive" string is the coprocessor response for ping command
- * and not a command, therefore it is terminated with "\r\n".
- */
-char alive[] = "$AL;38\r\n";
-char ping[] = "$PI;2C\n";
-
-int coprocessor_post_test(int flags)
-{
-       struct stdio_dev *cop_port;
-       int ret;
-       char buf[10];
-
-       /* Test IO Coprocessor communication */
-       cop_port = open_port(4, CONFIG_SYS_PDM360NG_COPROC_BAUDRATE);
-       if (!cop_port)
-               return -1;
-
-       write_port(cop_port, ping);
-       udelay(CONFIG_SYS_PDM360NG_COPROC_READ_DELAY);
-
-       memset(buf, 0, sizeof(buf));
-       ret = read_port(cop_port, buf, sizeof(buf));
-       close_port(4);
-       if (ret <= 0) {
-               post_log("Error: Can't read IO Coprocessor port.\n");
-               return -1;
-       }
-
-       if (strcmp(buf, alive)) {
-               post_log("Error: IO-Cop. resp.: %s\n", buf);
-               return -1;
-       }
-
-       /* Test WD Coprocessor communication */
-       cop_port = open_port(1, CONFIG_SYS_PDM360NG_COPROC_BAUDRATE);
-       if (!cop_port) {
-               post_log("Error: Can't open WD Coprocessor port.\n");
-               return -1;
-       }
-
-       write_port(cop_port, ping);
-       udelay(CONFIG_SYS_PDM360NG_COPROC_READ_DELAY);
-
-       memset(buf, 0, sizeof(buf));
-       ret = read_port(cop_port, buf, sizeof(buf));
-       close_port(1);
-       if (ret <= 0) {
-               post_log("Error: Can't read WD Coprocessor port.\n");
-               return -1;
-       }
-
-       if (strcmp(buf, alive)) {
-               post_log("Error: WD-Cop. resp.: %s\n", buf);
-               return -1;
-       }
-
-       return 0;
-}