projects / people / ms / u-boot.git / blame
| Commit | Line | Data |
|---|---|---|
| 2ffec69b DD |
1 | How to use U-Boot on Freescale MX6ULL 14x14 EVK |
| 2 | ---------------------------------------------- | |
| 3 | ||
| 4 | - First make sure you have installed the dtc package (device tree compiler): | |
| 5 | ||
| 6 | $ sudo apt-get install device-tree-compiler | |
| 7 | ||
| 8 | - Build U-Boot for MX6ULL 14x14 EVK: | |
| 9 | ||
| 10 | $ make mrproper | |
| 11 | $ make mx6ull_14x14_evk_defconfig | |
| 12 | $ make | |
| 13 | ||
| 14 | This generates the u-boot-dtb.imx image in the current directory. | |
| 15 | ||
| 16 | - Flash the u-boot-dtb.imx image into the micro SD card: | |
| 17 | ||
| 18 | $ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 && sync | |
| 19 | ||
| 20 | - Jumper settings: | |
| 21 | ||
| 22 | SW601: 0 0 1 0 | |
| 23 | Sw602: 1 0 | |
| 24 | ||
| 25 | Where 0 means bottom position and 1 means top position (from the switch label | |
| 26 | numbers reference). | |
| 27 | ||
| 28 | Connect the USB cable between the EVK and the PC for the console. | |
| 29 | (The USB console connector is the one close the push buttons) | |
| 30 | ||
| 31 | Insert the micro SD card in the board, power it up and U-Boot messages should | |
| 32 | come up. | |
| 33 | ||
| 34 | The link for the board: http://www.nxp.com/products/microcontrollers-and- \ | |
| 35 | processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \ | |
| 36 | i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK |