board: ge: bx50v3: Enable CONFIG_DM

[thirdparty/u-boot.git] / configs / pfla02_defconfig

CONFIG_ARM=y
CONFIG_ARCH_MX6=y
CONFIG_SYS_TEXT_BASE=0x17800000
CONFIG_SPL_GPIO_SUPPORT=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_TARGET_PFLA02=y
CONFIG_SPL_MMC_SUPPORT=y
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL=y
CONFIG_SPL_LIBDISK_SUPPORT=y
CONFIG_SPL_SPI_FLASH_SUPPORT=y
CONFIG_SPL_SPI_SUPPORT=y
CONFIG_CMD_HDMIDETECT=y
CONFIG_DISTRO_DEFAULTS=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_FIT=y
CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/spl_sd.cfg"
CONFIG_BOOTDELAY=3
# CONFIG_USE_BOOTCOMMAND is not set
CONFIG_DISPLAY_BOARDINFO_LATE=y
CONFIG_BOUNCE_BUFFER=y
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_SPL_DMA_SUPPORT=y
CONFIG_SPL_FS_EXT4=y
CONFIG_SPL_I2C_SUPPORT=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_SPL_WATCHDOG_SUPPORT=y
CONFIG_SPL_YMODEM_SUPPORT=y
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
# CONFIG_CMD_NAND is not set
CONFIG_CMD_SF=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_MTDPARTS=y
CONFIG_MTDIDS_DEFAULT="nand0=gpmi-nand"
CONFIG_MTDPARTS_DEFAULT="mtdparts=gpmi-nand:-(nand);spi2.0:1024k(bootloader),64k(env1),64k(env2),-(rescue)"
CONFIG_CMD_UBI=y
# CONFIG_SPL_PARTITION_UUIDS is not set
CONFIG_DM=y
CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_NAND=y
CONFIG_NAND_MXS=y
CONFIG_SPI_FLASH=y
CONFIG_SF_DEFAULT_BUS=2
CONFIG_SF_DEFAULT_MODE=0
CONFIG_SF_DEFAULT_SPEED=20000000
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_PHYLIB=y
CONFIG_PHY_MICREL=y
CONFIG_PHY_MICREL_KSZ90X1=y
CONFIG_FEC_MXC=y
CONFIG_MII=y
CONFIG_SPI=y
CONFIG_MXC_SPI=y
CONFIG_DM_THERMAL=y
CONFIG_OF_LIBFDT=y