projects / thirdparty / u-boot.git / blame
| Commit | Line | Data |
|---|---|---|
| 83d290c5 | 1 | // SPDX-License-Identifier: GPL-2.0+ |
| e5f495d1 PW |
2 | /* |
| 3 | * (C) Copyright 2010 | |
| 4 | * Marvell Semiconductor <www.marvell.com> | |
| 5 | * Written-by: Prafulla Wadaskar <prafulla@marvell.com>, | |
| e5f495d1 PW |
6 | */ |
| 7 | ||
| 8 | #include <common.h> | |
| 9 | #include <asm/io.h> | |
| 10 | #include <mvmfp.h> | |
| 11 | #include <asm/arch/mfp.h> | |
| e5f495d1 PW |
12 | |
| 13 | /* | |
| 14 | * mfp_config | |
| 15 | * | |
| 16 | * On most of Marvell SoCs (ex. ARMADA100) there is Multi-Funtion-Pin | |
| 17 | * configuration registers to configure each GPIO/Function pin on the | |
| 18 | * SoC. | |
| 19 | * | |
| 20 | * This function reads the array of values for | |
| 21 | * MFPR_X registers and programms them into respective | |
| 22 | * Multi-Function Pin registers. | |
| 23 | * It supports - Alternate Function Selection programming. | |
| 24 | * | |
| 25 | * Whereas, | |
| 26 | * The Configureation value is constructed using MFP() | |
| 27 | * array consists of 32bit values as defined in MFP(xx,xx..) macro | |
| 28 | */ | |
| 29 | void mfp_config(u32 *mfp_cfgs) | |
| 30 | { | |
| 31 | u32 *p_mfpr = NULL; | |
| 32 | u32 cfg_val, val; | |
| 33 | ||
| 34 | do { | |
| 35 | cfg_val = *mfp_cfgs++; | |
| 36 | /* exit if End of configuration table detected */ | |
| 37 | if (cfg_val == MFP_EOC) | |
| 38 | break; | |
| 39 | ||
| 40 | p_mfpr = (u32 *)(MV_MFPR_BASE | |
| 41 | + MFP_REG_GET_OFFSET(cfg_val)); | |
| 42 | ||
| 43 | /* Write a mfg register as per configuration */ | |
| 44 | val = 0; | |
| ee4303cf XW |
45 | if (cfg_val & MFP_VALUE_MASK) |
| 46 | val |= cfg_val & MFP_VALUE_MASK; | |
| e5f495d1 PW |
47 | |
| 48 | writel(val, p_mfpr); | |
| 49 | } while (1); | |
| 50 | /* | |
| 51 | * perform a read-back of any MFPR register to make sure the | |
| 52 | * previous writings are finished | |
| 53 | */ | |
| 54 | readl(p_mfpr); | |
| 55 | } |