[people/ms/u-boot.git] / include / configs / ls1012a_common.h

/*
 * Copyright 2016 Freescale Semiconductor
 *
 * SPDX-License-Identifier:	GPL-2.0+
 */

#ifndef __LS1012A_COMMON_H
#define __LS1012A_COMMON_H

#define CONFIG_FSL_LAYERSCAPE
#define CONFIG_FSL_LSCH2
#define CONFIG_LS1012A
#define CONFIG_GICV2

#define	CONFIG_SYS_HAS_SERDES

#include <asm/arch/config.h>
#define CONFIG_SYS_NO_FLASH

#define CONFIG_SUPPORT_RAW_INITRD

#define CONFIG_DISPLAY_BOARDINFO_LATE

#define CONFIG_SYS_TEXT_BASE		0x40100000

#define CONFIG_SYS_FSL_CLK
#define CONFIG_SYS_CLK_FREQ		100000000
#define CONFIG_DDR_CLK_FREQ		125000000

#define CONFIG_SKIP_LOWLEVEL_INIT
#define CONFIG_BOARD_EARLY_INIT_F	1

#define CONFIG_SYS_INIT_SP_ADDR		(CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
#define CONFIG_SYS_LOAD_ADDR	(CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)

#define CONFIG_SYS_DDR_SDRAM_BASE	0x80000000
#define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY	0
#define CONFIG_SYS_SDRAM_BASE		CONFIG_SYS_DDR_SDRAM_BASE

/* Generic Timer Definitions */
#define COUNTER_FREQUENCY		CONFIG_SYS_CLK_FREQ/4	/* 25MHz */

/* CSU */
#define CONFIG_LAYERSCAPE_NS_ACCESS

/* Size of malloc() pool */
#define CONFIG_SYS_MALLOC_LEN		(CONFIG_ENV_SIZE + 128 * 1024)

/*SPI device */
#ifdef CONFIG_QSPI_BOOT
#define CONFIG_SYS_QE_FW_IN_SPIFLASH
#define CONFIG_SYS_FMAN_FW_ADDR		0x400d0000
#define CONFIG_ENV_SPI_BUS		0
#define CONFIG_ENV_SPI_CS		0
#define CONFIG_ENV_SPI_MAX_HZ		1000000
#define CONFIG_ENV_SPI_MODE		0x03
#define CONFIG_SPI_FLASH_SPANSION
#define CONFIG_FSL_SPI_INTERFACE
#define CONFIG_SF_DATAFLASH

#define CONFIG_FSL_QSPI
#define QSPI0_AMBA_BASE		0x40000000
#define CONFIG_SPI_FLASH_SPANSION
#define CONFIG_SPI_FLASH_BAR

#define FSL_QSPI_FLASH_SIZE		(1 << 24)
#define FSL_QSPI_FLASH_NUM		2

/*
 * Environment
 */
#define CONFIG_ENV_OVERWRITE

#define CONFIG_ENV_IS_IN_SPI_FLASH
#define CONFIG_ENV_SIZE			0x40000          /* 256KB */
#define CONFIG_ENV_OFFSET		0x200000        /* 2MB */
#define CONFIG_ENV_SECT_SIZE		0x40000
#endif

/* I2C */
#define CONFIG_SYS_I2C
#define CONFIG_SYS_I2C_MXC
#define CONFIG_SYS_I2C_MXC_I2C1		/* enable I2C bus 1 */
#define CONFIG_SYS_I2C_MXC_I2C2		/* enable I2C bus 2 */

#define CONFIG_CONS_INDEX       1
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_SYS_NS16550_REG_SIZE     1
#define CONFIG_SYS_NS16550_CLK          (get_bus_freq(0)/2)

#define CONFIG_BAUDRATE			115200
#define CONFIG_SYS_BAUDRATE_TABLE	{ 9600, 19200, 38400, 57600, 115200 }

/* Command line configuration */
#define CONFIG_CMD_ENV
#undef CONFIG_CMD_IMLS

#define CONFIG_ARCH_EARLY_INIT_R

#define CONFIG_SYS_HZ			1000

#define CONFIG_HWCONFIG
#define HWCONFIG_BUFFER_SIZE		128

#define CONFIG_DISPLAY_CPUINFO

/* Initial environment variables */
#define CONFIG_EXTRA_ENV_SETTINGS		\
	"initrd_high=0xffffffff\0"		\
	"verify=no\0"				\
	"hwconfig=fsl_ddr:bank_intlv=auto\0"	\
	"loadaddr=0x80100000\0"			\
	"kernel_addr=0x100000\0"		\
	"ramdisk_addr=0x800000\0"		\
	"ramdisk_size=0x2000000\0"		\
	"fdt_high=0xffffffffffffffff\0"		\
	"initrd_high=0xffffffffffffffff\0"	\
	"kernel_start=0xa00000\0"		\
	"kernel_load=0xa0000000\0"		\
	"kernel_size=0x2800000\0"		\
	"console=ttyAMA0,38400n8\0"

#define CONFIG_BOOTARGS		"console=ttyS0,115200 root=/dev/ram0 " \
				"earlycon=uart8250,mmio,0x21c0500"
#define CONFIG_BOOTCOMMAND		"sf probe 0:0; sf read $kernel_load "\
					"$kernel_start $kernel_size && "\
					"bootm $kernel_load"
#define CONFIG_BOOTDELAY		10

/* Monitor Command Prompt */
#define CONFIG_SYS_CBSIZE		512	/* Console I/O Buffer Size */
#define CONFIG_SYS_PBSIZE		(CONFIG_SYS_CBSIZE + \
					sizeof(CONFIG_SYS_PROMPT) + 16)
#define CONFIG_SYS_BARGSIZE		CONFIG_SYS_CBSIZE /* Boot args buffer */
#define CONFIG_SYS_LONGHELP
#define CONFIG_CMDLINE_EDITING		1
#define CONFIG_AUTO_COMPLETE
#define CONFIG_SYS_MAXARGS		64	/* max command args */

#define CONFIG_PANIC_HANG
#define CONFIG_SYS_BOOTM_LEN   (64 << 20)      /* Increase max gunzip size */

#include <asm/fsl_secure_boot.h>

#endif /* __LS1012A_COMMON_H */
Commit	Line	Data
9d044fcb PK	1	/*
	2	* Copyright 2016 Freescale Semiconductor
	3	*
	4	* SPDX-License-Identifier: GPL-2.0+
	5	*/
	6
	7	#ifndef __LS1012A_COMMON_H
	8	#define __LS1012A_COMMON_H
	9
	10	#define CONFIG_FSL_LAYERSCAPE
	11	#define CONFIG_FSL_LSCH2
	12	#define CONFIG_LS1012A
	13	#define CONFIG_GICV2
	14
	15	#define CONFIG_SYS_HAS_SERDES
	16
	17	#include <asm/arch/config.h>
	18	#define CONFIG_SYS_NO_FLASH
	19
	20	#define CONFIG_SUPPORT_RAW_INITRD
	21
	22	#define CONFIG_DISPLAY_BOARDINFO_LATE
	23
	24	#define CONFIG_SYS_TEXT_BASE 0x40100000
	25
	26	#define CONFIG_SYS_FSL_CLK
	27	#define CONFIG_SYS_CLK_FREQ 100000000
	28	#define CONFIG_DDR_CLK_FREQ 125000000
	29
	30	#define CONFIG_SKIP_LOWLEVEL_INIT
	31	#define CONFIG_BOARD_EARLY_INIT_F 1
	32
	33	#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
	34	#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
	35
	36	#define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000
	37	#define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0
	38	#define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE
	39
	40	/* Generic Timer Definitions */
	41	#define COUNTER_FREQUENCY CONFIG_SYS_CLK_FREQ/4 /* 25MHz */
	42
	43	/* CSU */
	44	#define CONFIG_LAYERSCAPE_NS_ACCESS
	45
	46	/* Size of malloc() pool */
	47	#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024)
	48
	49	/SPI device /
	50	#ifdef CONFIG_QSPI_BOOT
	51	#define CONFIG_SYS_QE_FW_IN_SPIFLASH
	52	#define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000
	53	#define CONFIG_ENV_SPI_BUS 0
	54	#define CONFIG_ENV_SPI_CS 0
	55	#define CONFIG_ENV_SPI_MAX_HZ 1000000
	56	#define CONFIG_ENV_SPI_MODE 0x03
	57	#define CONFIG_SPI_FLASH_SPANSION
	58	#define CONFIG_FSL_SPI_INTERFACE
	59	#define CONFIG_SF_DATAFLASH
	60
	61	#define CONFIG_FSL_QSPI
	62	#define QSPI0_AMBA_BASE 0x40000000
	63	#define CONFIG_SPI_FLASH_SPANSION
	64	#define CONFIG_SPI_FLASH_BAR
65
66	#define FSL_QSPI_FLASH_SIZE (1 << 24)
67	#define FSL_QSPI_FLASH_NUM 2
68
69	/*
70	* Environment
71	*/
72	#define CONFIG_ENV_OVERWRITE
73
74	#define CONFIG_ENV_IS_IN_SPI_FLASH
75	#define CONFIG_ENV_SIZE 0x40000 /* 256KB */
76	#define CONFIG_ENV_OFFSET 0x200000 /* 2MB */
77	#define CONFIG_ENV_SECT_SIZE 0x40000
78	#endif
79
80	/* I2C */
81	#define CONFIG_SYS_I2C
82	#define CONFIG_SYS_I2C_MXC
83	#define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */
84	#define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */
85
86	#define CONFIG_CONS_INDEX 1
87	#define CONFIG_SYS_NS16550_SERIAL
88	#define CONFIG_SYS_NS16550_REG_SIZE 1
89	#define CONFIG_SYS_NS16550_CLK (get_bus_freq(0)/2)
90
91	#define CONFIG_BAUDRATE 115200
92	#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
93
94	/* Command line configuration */
95	#define CONFIG_CMD_ENV
96	#undef CONFIG_CMD_IMLS
97
98	#define CONFIG_ARCH_EARLY_INIT_R
99
100	#define CONFIG_SYS_HZ 1000
101
102	#define CONFIG_HWCONFIG
103	#define HWCONFIG_BUFFER_SIZE 128
104
105	#define CONFIG_DISPLAY_CPUINFO
106
107	/* Initial environment variables */
108	#define CONFIG_EXTRA_ENV_SETTINGS \
109	"initrd_high=0xffffffff\0" \
110	"verify=no\0" \
111	"hwconfig=fsl_ddr:bank_intlv=auto\0" \
112	"loadaddr=0x80100000\0" \
113	"kernel_addr=0x100000\0" \
114	"ramdisk_addr=0x800000\0" \
115	"ramdisk_size=0x2000000\0" \
116	"fdt_high=0xffffffffffffffff\0" \
117	"initrd_high=0xffffffffffffffff\0" \
118	"kernel_start=0xa00000\0" \
119	"kernel_load=0xa0000000\0" \
120	"kernel_size=0x2800000\0" \
121	"console=ttyAMA0,38400n8\0"
122
123	#define CONFIG_BOOTARGS "console=ttyS0,115200 root=/dev/ram0 " \
124	"earlycon=uart8250,mmio,0x21c0500"
125	#define CONFIG_BOOTCOMMAND "sf probe 0:0; sf read $kernel_load "\
126	"$kernel_start $kernel_size && "\
127	"bootm $kernel_load"
128	#define CONFIG_BOOTDELAY 10
129
130	/* Monitor Command Prompt */
131	#define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
132	#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \
133	sizeof(CONFIG_SYS_PROMPT) + 16)
134	#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot args buffer */
135	#define CONFIG_SYS_LONGHELP
136	#define CONFIG_CMDLINE_EDITING 1
137	#define CONFIG_AUTO_COMPLETE
138	#define CONFIG_SYS_MAXARGS 64 /* max command args */
139
140	#define CONFIG_PANIC_HANG
141	#define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */
142
143	#include <asm/fsl_secure_boot.h>
144
145	#endif /* __LS1012A_COMMON_H */