Bindings/media/i2c/toshiba,tc358746.yaml

   1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
   2 %YAML 1.2
   3 ---
   4 $id: http://devicetree.org/schemas/media/i2c/toshiba,tc358746.yaml#
   5 $schema: http://devicetree.org/meta-schemas/core.yaml#
   6
   7 title: Toshiba TC358746 Parallel to MIPI CSI2 Bridge
   8
   9 maintainers:
  10   - Marco Felsch <kernel@pengutronix.de>
  11
  12 description: |-
  13   The Toshiba TC358746 converts a parallel video stream into a MIPI CSI-2
  14   stream. The direction can be either parallel-in -> csi-out or csi-in ->
  15   parallel-out The chip is programmable through I2C and SPI but the SPI
  16   interface is only supported in parallel-in -> csi-out mode.
  17
  18   Note that the current device tree bindings only support the
  19   parallel-in -> csi-out path.
  20
  21 properties:
  22   compatible:
  23     const: toshiba,tc358746
  24
  25   reg:
  26     maxItems: 1
  27
  28   clocks:
  29     description:
  30       The phandle to the reference clock source. This corresponds to the
  31       hardware pin REFCLK.
  32     maxItems: 1
  33
  34   clock-names:
  35     const: refclk
  36
  37   "#clock-cells":
  38     description: |
  39       The bridge can act as clock provider for the sensor. To enable this
  40       support #clock-cells must be specified. Attention if this feature is used
  41       then the mclk rate must be at least: (2 * link-frequency) / 8
  42                                            `------------------´   ^
  43                                            internal PLL rate   smallest possible
  44                                                                    mclk-div
  45     const: 0
  46
  47   clock-output-names:
  48     description:
  49       The clock name of the MCLK output, the default name is tc358746-mclk.
  50     maxItems: 1
  51
  52   vddc-supply:
  53     description: Digital core voltage supply, 1.2 volts
  54
  55   vddio-supply:
  56     description: Digital I/O voltage supply, 1.8 volts
  57
  58   vddmipi-supply:
  59     description: MIPI CSI phy voltage supply, 1.2 volts
  60
  61   reset-gpios:
  62     description:
  63       The phandle and specifier for the GPIO that controls the chip reset.
  64       This corresponds to the hardware pin RESX which is physically active low.
  65     maxItems: 1
  66
  67   ports:
  68     $ref: /schemas/graph.yaml#/properties/ports
  69     properties:
  70       port@0:
  71         $ref: /schemas/graph.yaml#/$defs/port-base
  72         unevaluatedProperties: false
  73         description: Input port
  74
  75         properties:
  76           endpoint:
  77             $ref: /schemas/media/video-interfaces.yaml#
  78             unevaluatedProperties: false
  79
  80             properties:
  81               hsync-active: true
  82               vsync-active: true
  83               bus-type:
  84                 enum: [ 5, 6 ]
  85
  86             required:
  87               - hsync-active
  88               - vsync-active
  89               - bus-type
  90
  91       port@1:
  92         $ref: /schemas/graph.yaml#/$defs/port-base
  93         unevaluatedProperties: false
  94         description: Output port
  95
  96         properties:
  97           endpoint:
  98             $ref: /schemas/media/video-interfaces.yaml#
  99             unevaluatedProperties: false
 100
 101             properties:
 102               data-lanes:
 103                 minItems: 1
 104                 maxItems: 4
 105
 106               clock-noncontinuous: true
 107               link-frequencies: true
 108
 109             required:
 110               - data-lanes
 111               - link-frequencies
 112
 113     required:
 114       - port@0
 115       - port@1
 116
 117 required:
 118   - compatible
 119   - reg
 120   - clocks
 121   - clock-names
 122   - vddc-supply
 123   - vddio-supply
 124   - vddmipi-supply
 125   - ports
 126
 127 additionalProperties: false
 128
 129 examples:
 130   - |
 131     #include <dt-bindings/gpio/gpio.h>
 132
 133     i2c {
 134       #address-cells = <1>;
 135       #size-cells = <0>;
 136
 137       csi-bridge@e {
 138         compatible = "toshiba,tc358746";
 139         reg = <0xe>;
 140
 141         clocks = <&refclk>;
 142         clock-names = "refclk";
 143
 144         reset-gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
 145
 146         vddc-supply = <&v1_2d>;
 147         vddio-supply = <&v1_8d>;
 148         vddmipi-supply = <&v1_2d>;
 149
 150         /* sensor mclk provider */
 151         #clock-cells = <0>;
 152
 153         ports {
 154           #address-cells = <1>;
 155           #size-cells = <0>;
 156
 157           /* Input */
 158           port@0 {
 159             reg = <0>;
 160             tc358746_in: endpoint {
 161               remote-endpoint = <&sensor_out>;
 162               hsync-active = <0>;
 163               vsync-active = <0>;
 164               bus-type = <5>;
 165             };
 166           };
 167
 168           /* Output */
 169           port@1 {
 170             reg = <1>;
 171             tc358746_out: endpoint {
 172               remote-endpoint = <&mipi_csi2_in>;
 173               data-lanes = <1 2>;
 174               clock-noncontinuous;
 175               link-frequencies = /bits/ 64 <216000000>;
 176             };
 177           };
 178         };
 179       };
 180     };