Bindings/mtd/fsl-upm-nand.txt

   1 Freescale Localbus UPM programmed to work with NAND flash
   2
   3 Required properties:
   4 - compatible : "fsl,upm-nand".
   5 - reg : should specify localbus chip select and size used for the chip.
   6 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
   7 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
   8
   9 Optional properties:
  10 - fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
  11         The corresponding address lines are used to select the chip.
  12 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
  13         (R/B#). For multi-chip devices, "n" GPIO definitions are required
  14         according to the number of chips.
  15
  16 Deprecated properties:
  17 - fsl,upm-wait-flags : add chip-dependent short delays after running the
  18         UPM pattern (0x1), after writing a data byte (0x2) or after
  19         writing out a buffer (0x4).
  20 - chip-delay : chip dependent delay for transferring data from array to
  21         read registers (tR). Required if property "gpios" is not used
  22         (R/B# pins not connected).
  23
  24 Each flash chip described may optionally contain additional sub-nodes
  25 describing partitions of the address space. See partition.txt for more
  26 detail.
  27
  28 Examples:
  29
  30 upm@1,0 {
  31         compatible = "fsl,upm-nand";
  32         reg = <1 0 1>;
  33         fsl,upm-addr-offset = <16>;
  34         fsl,upm-cmd-offset = <8>;
  35         gpios = <&qe_pio_e 18 0>;
  36
  37         flash {
  38                 #address-cells = <1>;
  39                 #size-cells = <1>;
  40                 compatible = "...";
  41
  42                 partition@0 {
  43                         ...
  44                 };
  45         };
  46 };
  47
  48 upm@3,0 {
  49         #address-cells = <0>;
  50         #size-cells = <0>;
  51         compatible = "tqc,tqm8548-upm-nand", "fsl,upm-nand";
  52         reg = <3 0x0 0x800>;
  53         fsl,upm-addr-offset = <0x10>;
  54         fsl,upm-cmd-offset = <0x08>;
  55         /* Multi-chip NAND device */
  56         fsl,upm-addr-line-cs-offsets = <0x0 0x200>;
  57
  58         nand@0 {
  59                 #address-cells = <1>;
  60                 #size-cells = <1>;
  61
  62                 partition@0 {
  63                             label = "fs";
  64                             reg = <0x00000000 0x10000000>;
  65                 };
  66         };
  67 };