]>
git.ipfire.org Git - thirdparty/linux.git/blob - arch/arm/mach-ixp4xx/include/mach/platform.h
2 * arch/arm/mach-ixp4xx/include/mach/platform.h
4 * Constants and functions that are useful to IXP4xx platform-specific code
7 * Copyright (C) 2004 MontaVista Software, Inc.
10 #ifndef __ASM_ARCH_HARDWARE_H__
11 #error "Do not include this directly, instead #include <mach/hardware.h>"
16 #include <asm/types.h>
25 * Expansion bus memory regions
27 #define IXP4XX_EXP_BUS_BASE_PHYS (0x50000000)
30 * The expansion bus on the IXP4xx can be configured for either 16 or
31 * 32MB windows and the CS offset for each region changes based on the
32 * current configuration. This means that we cannot simply hardcode
33 * each offset. ixp4xx_sys_init() looks at the expansion bus configuration
34 * as setup by the bootloader to determine our window size.
36 extern unsigned long ixp4xx_exp_bus_size
;
38 #define IXP4XX_EXP_BUS_BASE(region)\
39 (IXP4XX_EXP_BUS_BASE_PHYS + ((region) * ixp4xx_exp_bus_size))
41 #define IXP4XX_EXP_BUS_END(region)\
42 (IXP4XX_EXP_BUS_BASE(region) + ixp4xx_exp_bus_size - 1)
44 /* Those macros can be used to adjust timing and configure
45 * other features for each region.
48 #define IXP4XX_EXP_BUS_RECOVERY_T(x) (((x) & 0x0f) << 16)
49 #define IXP4XX_EXP_BUS_HOLD_T(x) (((x) & 0x03) << 20)
50 #define IXP4XX_EXP_BUS_STROBE_T(x) (((x) & 0x0f) << 22)
51 #define IXP4XX_EXP_BUS_SETUP_T(x) (((x) & 0x03) << 26)
52 #define IXP4XX_EXP_BUS_ADDR_T(x) (((x) & 0x03) << 28)
53 #define IXP4XX_EXP_BUS_SIZE(x) (((x) & 0x0f) << 10)
54 #define IXP4XX_EXP_BUS_CYCLES(x) (((x) & 0x03) << 14)
56 #define IXP4XX_EXP_BUS_CS_EN (1L << 31)
57 #define IXP4XX_EXP_BUS_BYTE_RD16 (1L << 6)
58 #define IXP4XX_EXP_BUS_HRDY_POL (1L << 5)
59 #define IXP4XX_EXP_BUS_MUX_EN (1L << 4)
60 #define IXP4XX_EXP_BUS_SPLT_EN (1L << 3)
61 #define IXP4XX_EXP_BUS_WR_EN (1L << 1)
62 #define IXP4XX_EXP_BUS_BYTE_EN (1L << 0)
64 #define IXP4XX_EXP_BUS_CYCLES_INTEL 0x00
65 #define IXP4XX_EXP_BUS_CYCLES_MOTOROLA 0x01
66 #define IXP4XX_EXP_BUS_CYCLES_HPI 0x02
68 #define IXP4XX_FLASH_WRITABLE (0x2)
69 #define IXP4XX_FLASH_DEFAULT (0xbcd23c40)
70 #define IXP4XX_FLASH_WRITE (0xbcd23c42)
73 * Clock Speed Definitions.
75 #define IXP4XX_PERIPHERAL_BUS_CLOCK (66) /* 66Mhzi APB BUS */
76 #define IXP4XX_UART_XTAL 14745600
79 * This structure provide a means for the board setup code
80 * to give information to th pata_ixp4xx driver. It is
81 * passed as platform_data.
83 struct ixp4xx_pata_data
{
84 volatile u32
*cs0_cfg
;
85 volatile u32
*cs1_cfg
;
86 unsigned long cs0_bits
;
87 unsigned long cs1_bits
;
92 #define IXP4XX_ETH_NPEA 0x00
93 #define IXP4XX_ETH_NPEB 0x10
94 #define IXP4XX_ETH_NPEC 0x20
96 /* Information about built-in Ethernet MAC interfaces */
97 struct eth_plat_info
{
98 u8 phy
; /* MII PHY ID, 0 - 31 */
99 u8 rxq
; /* configurable, currently 0 - 31 only */
104 /* Information about built-in HSS (synchronous serial) interfaces */
105 struct hss_plat_info
{
106 int (*set_clock
)(int port
, unsigned int clock_type
);
107 int (*open
)(int port
, void *pdev
,
108 void (*set_carrier_cb
)(void *pdev
, int carrier
));
109 void (*close
)(int port
, void *pdev
);
114 * Frequency of clock used for primary clocksource
116 extern unsigned long ixp4xx_timer_freq
;
119 * Functions used by platform-level setup code
121 extern void ixp4xx_map_io(void);
122 extern void ixp4xx_init_early(void);
123 extern void ixp4xx_init_irq(void);
124 extern void ixp4xx_sys_init(void);
125 extern void ixp4xx_timer_init(void);
126 extern void ixp4xx_restart(char, const char *);
127 extern void ixp4xx_pci_preinit(void);
129 extern int ixp4xx_setup(int nr
, struct pci_sys_data
*sys
);
130 extern struct pci_ops ixp4xx_ops
;
136 * The following converted to the real HW bits the gpio_line_config
139 #define IXP4XX_GPIO_OUT 0x1
140 #define IXP4XX_GPIO_IN 0x2
142 /* GPIO signal types */
143 #define IXP4XX_GPIO_LOW 0
144 #define IXP4XX_GPIO_HIGH 1
147 #define IXP4XX_GPIO_CLK_0 14
148 #define IXP4XX_GPIO_CLK_1 15
150 static inline void gpio_line_config(u8 line
, u32 direction
)
152 if (direction
== IXP4XX_GPIO_IN
)
153 *IXP4XX_GPIO_GPOER
|= (1 << line
);
155 *IXP4XX_GPIO_GPOER
&= ~(1 << line
);
158 static inline void gpio_line_get(u8 line
, int *value
)
160 *value
= (*IXP4XX_GPIO_GPINR
>> line
) & 0x1;
163 static inline void gpio_line_set(u8 line
, int value
)
165 if (value
== IXP4XX_GPIO_HIGH
)
166 *IXP4XX_GPIO_GPOUTR
|= (1 << line
);
167 else if (value
== IXP4XX_GPIO_LOW
)
168 *IXP4XX_GPIO_GPOUTR
&= ~(1 << line
);
171 #endif // __ASSEMBLY__