doc/README.sh7785lcr

   1 ========================================
   2 Renesas Technology R0P7785LC0011RL board
   3 ========================================
   4
   5 This board specification:
   6 =========================
   7
   8 The R0P7785LC0011RL(board config name:sh7785lcr) has the following device:
   9
  10  - SH7785 (SH-4A)
  11  - DDR2-SDRAM 512MB
  12  - NOR Flash 64MB
  13  - 2D Graphic controller
  14  - SATA controller
  15  - Ethernet controller
  16  - USB host/peripheral controller
  17  - SD controller
  18  - I2C controller
  19  - RTC
  20
  21 This board has 2 physical memory maps. It can be changed with DIP switch(S2-5).
  22
  23  phys address                   | S2-5 = OFF    | S2-5 = ON
  24  -------------------------------+---------------+---------------
  25  0x00000000 - 0x03ffffff(CS0)   | NOR Flash     | NOR Flash
  26  0x04000000 - 0x05ffffff(CS1)   | PLD           | PLD
  27  0x06000000 - 0x07ffffff(CS1)   | reserved      | I2C
  28  0x08000000 - 0x0bffffff(CS2)   | USB           | DDR SDRAM
  29  0x0c000000 - 0x0fffffff(CS3)   | SD            | DDR SDRAM
  30  0x10000000 - 0x13ffffff(CS4)   | SM107         | SM107
  31  0x14000000 - 0x17ffffff(CS5)   | I2C           | USB
  32  0x18000000 - 0x1bffffff(CS6)   | reserved      | SD
  33  0x40000000 - 0x5fffffff        | DDR SDRAM     | (cannot use)
  34
  35
  36 This board specific command:
  37 ============================
  38
  39 This board has the following its specific command:
  40
  41  - hwtest
  42  - printmac
  43  - setmac
  44
  45
  46 1. hwtest
  47
  48 This is self-check command. This command has the following options:
  49
  50  - all          : test all hardware
  51  - pld          : output PLD version
  52  - led          : turn on LEDs
  53  - dipsw        : test DIP switch
  54  - sm107        : output SM107 version
  55  - net          : check RTL8110 ID
  56  - sata         : check SiI3512 ID
  57  - net          : output PCI slot device ID
  58
  59 i.e)
  60 => hwtest led
  61 turn on LEDs 3, 5, 7, 9
  62 turn on LEDs 4, 6, 8, 10
  63
  64 => hwtest net
  65 Ethernet OK
  66
  67
  68 2. printmac
  69
  70 This command outputs MAC address of this board.
  71
  72 i.e)
  73 => printmac
  74 MAC = 00:00:87:**:**:**
  75
  76
  77 3. setmac
  78
  79 This command writes MAC address of this board.
  80
  81 i.e)
  82 => setmac 00:00:87:**:**:**
  83