include/configs/M5275EVB.h

   1 /*
   2  * Configuation settings for the Motorola MC5275EVB board.
   3  *
   4  * By Arthur Shipkowski <art@videon-central.com>
   5  * Copyright (C) 2005 Videon Central, Inc.
   6  *
   7  * Based off of M5272C3 board code by Josef Baumgartner
   8  * <josef.baumgartner@telex.de>
   9  *
  10  * SPDX-License-Identifier:     GPL-2.0+
  11  */
  12
  13 /*
  14  * board/config.h - configuration options, board specific
  15  */
  16
  17 #ifndef _M5275EVB_H
  18 #define _M5275EVB_H
  19
  20 /*
  21  * High Level Configuration Options
  22  * (easy to change)
  23  */
  24 #define CONFIG_MCF52x2                  /* define processor family */
  25 #define CONFIG_M5275                    /* define processor type */
  26 #define CONFIG_M5275EVB                 /* define board type */
  27
  28 #define CONFIG_MCFTMR
  29
  30 #define CONFIG_MCFUART
  31 #define CONFIG_SYS_UART_PORT            (0)
  32 #define CONFIG_BAUDRATE         115200
  33
  34 /* Configuration for environment
  35  * Environment is embedded in u-boot in the second sector of the flash
  36  */
  37 #ifndef CONFIG_MONITOR_IS_IN_RAM
  38 #define CONFIG_ENV_OFFSET               0x4000
  39 #define CONFIG_ENV_SECT_SIZE    0x2000
  40 #define CONFIG_ENV_IS_IN_FLASH  1
  41 #else
  42 #define CONFIG_ENV_ADDR         0xffe04000
  43 #define CONFIG_ENV_SECT_SIZE    0x2000
  44 #define CONFIG_ENV_IS_IN_FLASH  1
  45 #endif
  46
  47 /*
  48  * BOOTP options
  49  */
  50 #define CONFIG_BOOTP_BOOTFILESIZE
  51 #define CONFIG_BOOTP_BOOTPATH
  52 #define CONFIG_BOOTP_GATEWAY
  53 #define CONFIG_BOOTP_HOSTNAME
  54
  55 /* Available command configuration */
  56 #include <config_cmd_default.h>
  57
  58 #define CONFIG_CMD_CACHE
  59 #define CONFIG_CMD_PING
  60 #define CONFIG_CMD_MII
  61 #define CONFIG_CMD_NET
  62 #define CONFIG_CMD_ELF
  63 #define CONFIG_CMD_FLASH
  64 #define CONFIG_CMD_I2C
  65 #define CONFIG_CMD_MEMORY
  66 #define CONFIG_CMD_DHCP
  67
  68 #undef CONFIG_CMD_LOADS
  69 #undef CONFIG_CMD_LOADB
  70
  71 #define CONFIG_MCFFEC
  72 #ifdef CONFIG_MCFFEC
  73 #define CONFIG_MII              1
  74 #define CONFIG_MII_INIT         1
  75 #define CONFIG_SYS_DISCOVER_PHY
  76 #define CONFIG_SYS_RX_ETH_BUFFER        8
  77 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  78 #define CONFIG_SYS_FEC0_PINMUX          0
  79 #define CONFIG_SYS_FEC0_MIIBASE CONFIG_SYS_FEC0_IOBASE
  80 #define CONFIG_SYS_FEC1_PINMUX          0
  81 #define CONFIG_SYS_FEC1_MIIBASE CONFIG_SYS_FEC1_IOBASE
  82 #define MCFFEC_TOUT_LOOP        50000
  83 #define CONFIG_HAS_ETH1
  84 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
  85 #ifndef CONFIG_SYS_DISCOVER_PHY
  86 #define FECDUPLEX               FULL
  87 #define FECSPEED                _100BASET
  88 #else
  89 #ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  90 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  91 #endif
  92 #endif
  93 #endif
  94
  95 /* I2C */
  96 #define CONFIG_SYS_I2C
  97 #define CONFIG_SYS_I2C_FSL
  98 #define CONFIG_SYS_FSL_I2C_SPEED        80000
  99 #define CONFIG_SYS_FSL_I2C_SLAVE        0x7F
 100 #define CONFIG_SYS_FSL_I2C_OFFSET       0x00000300
 101 #define CONFIG_SYS_IMMR         CONFIG_SYS_MBAR
 102 #define CONFIG_SYS_I2C_PINMUX_REG       (gpio_reg->par_feci2c)
 103 #define CONFIG_SYS_I2C_PINMUX_CLR       (0xFFF0)
 104 #define CONFIG_SYS_I2C_PINMUX_SET       (0x000F)
 105
 106 #define CONFIG_SYS_PROMPT               "-> "
 107 #define CONFIG_SYS_LONGHELP             /* undef to save memory */
 108
 109 #if (CONFIG_CMD_KGDB)
 110 #       define CONFIG_SYS_CBSIZE        1024
 111 #else
 112 #       define CONFIG_SYS_CBSIZE        256
 113 #endif
 114 #define CONFIG_SYS_PBSIZE               (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
 115 #define CONFIG_SYS_MAXARGS              16
 116 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
 117
 118 #define CONFIG_SYS_LOAD_ADDR            0x800000
 119
 120 #define CONFIG_BOOTDELAY        5
 121 #define CONFIG_BOOTCOMMAND      "bootm ffe40000"
 122 #define CONFIG_SYS_MEMTEST_START        0x400
 123 #define CONFIG_SYS_MEMTEST_END          0x380000
 124
 125 #ifdef CONFIG_MCFFEC
 126 #       define CONFIG_NET_RETRY_COUNT   5
 127 #       define CONFIG_OVERWRITE_ETHADDR_ONCE
 128 #endif                          /* FEC_ENET */
 129
 130 #define CONFIG_EXTRA_ENV_SETTINGS               \
 131         "netdev=eth0\0"                         \
 132         "loadaddr=10000\0"                      \
 133         "uboot=u-boot.bin\0"                    \
 134         "load=tftp ${loadaddr} ${uboot}\0"      \
 135         "upd=run load; run prog\0"              \
 136         "prog=prot off ffe00000 ffe3ffff;"      \
 137         "era ffe00000 ffe3ffff;"                \
 138         "cp.b ${loadaddr} ffe00000 ${filesize};"\
 139         "save\0"                                \
 140         ""
 141
 142 #define CONFIG_SYS_HZ                   1000
 143 #define CONFIG_SYS_CLK                  150000000
 144
 145 /*
 146  * Low Level Configuration Settings
 147  * (address mappings, register initial values, etc.)
 148  * You should know what you are doing if you make changes here.
 149  */
 150
 151 #define CONFIG_SYS_MBAR         0x40000000
 152
 153 /*-----------------------------------------------------------------------
 154  * Definitions for initial stack pointer and data area (in DPRAM)
 155  */
 156 #define CONFIG_SYS_INIT_RAM_ADDR        0x20000000
 157 #define CONFIG_SYS_INIT_RAM_SIZE        0x10000 /* Size of used area in internal SRAM */
 158 #define CONFIG_SYS_GBL_DATA_OFFSET      (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 159 #define CONFIG_SYS_INIT_SP_OFFSET       CONFIG_SYS_GBL_DATA_OFFSET
 160
 161 /*-----------------------------------------------------------------------
 162  * Start addresses for the final memory configuration
 163  * (Set up by the startup code)
 164  * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
 165  */
 166 #define CONFIG_SYS_SDRAM_BASE           0x00000000
 167 #define CONFIG_SYS_SDRAM_SIZE           16      /* SDRAM size in MB */
 168 #define CONFIG_SYS_FLASH_BASE           CONFIG_SYS_CS0_BASE
 169
 170 #ifdef CONFIG_MONITOR_IS_IN_RAM
 171 #define CONFIG_SYS_MONITOR_BASE 0x20000
 172 #else
 173 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400)
 174 #endif
 175
 176 #define CONFIG_SYS_MONITOR_LEN          0x20000
 177 #define CONFIG_SYS_MALLOC_LEN           (256 << 10)
 178 #define CONFIG_SYS_BOOTPARAMS_LEN       64*1024
 179
 180 /*
 181  * For booting Linux, the board info and command line data
 182  * have to be in the first 8 MB of memory, since this is
 183  * the maximum mapped by the Linux kernel during initialization ??
 184  */
 185 #define CONFIG_SYS_BOOTMAPSZ            (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
 186 #define CONFIG_SYS_BOOTM_LEN            (CONFIG_SYS_SDRAM_SIZE << 20)
 187
 188 /*-----------------------------------------------------------------------
 189  * FLASH organization
 190  */
 191 #define CONFIG_SYS_MAX_FLASH_BANKS      1       /* max number of memory banks */
 192 #define CONFIG_SYS_MAX_FLASH_SECT       11      /* max number of sectors on one chip */
 193 #define CONFIG_SYS_FLASH_ERASE_TOUT     1000
 194
 195 #define CONFIG_SYS_FLASH_CFI            1
 196 #define CONFIG_FLASH_CFI_DRIVER 1
 197 #define CONFIG_SYS_FLASH_SIZE           0x200000
 198
 199 /*-----------------------------------------------------------------------
 200  * Cache Configuration
 201  */
 202 #define CONFIG_SYS_CACHELINE_SIZE       16
 203
 204 #define ICACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
 205                                          CONFIG_SYS_INIT_RAM_SIZE - 8)
 206 #define DCACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
 207                                          CONFIG_SYS_INIT_RAM_SIZE - 4)
 208 #define CONFIG_SYS_ICACHE_INV           (CF_CACR_CINV | CF_CACR_INVI)
 209 #define CONFIG_SYS_CACHE_ACR0           (CONFIG_SYS_SDRAM_BASE | \
 210                                          CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
 211                                          CF_ACR_EN | CF_ACR_SM_ALL)
 212 #define CONFIG_SYS_CACHE_ICACR          (CF_CACR_CENB | CF_CACR_CINV | \
 213                                          CF_CACR_DISD | CF_CACR_INVI | \
 214                                          CF_CACR_CEIB | CF_CACR_DCM | \
 215                                          CF_CACR_EUSP)
 216
 217 /*-----------------------------------------------------------------------
 218  * Memory bank definitions
 219  */
 220 #define CONFIG_SYS_CS0_BASE             0xffe00000
 221 #define CONFIG_SYS_CS0_CTRL             0x00001980
 222 #define CONFIG_SYS_CS0_MASK             0x001F0001
 223
 224 #define CONFIG_SYS_CS1_BASE             0x30000000
 225 #define CONFIG_SYS_CS1_CTRL             0x00001900
 226 #define CONFIG_SYS_CS1_MASK             0x00070001
 227
 228 /*-----------------------------------------------------------------------
 229  * Port configuration
 230  */
 231 #define CONFIG_SYS_FECI2C               0x0FA0
 232
 233 #endif  /* _M5275EVB_H */