include/configs/davinci_dm365evm.h

   1 /*
   2  * Copyright (C) 2009 Texas Instruments Incorporated
   3  *
   4  * SPDX-License-Identifier:     GPL-2.0+
   5  */
   6
   7 #ifndef __CONFIG_H
   8 #define __CONFIG_H
   9
  10 /* Spectrum Digital TMS320DM365 EVM board */
  11 #define DAVINCI_DM365EVM
  12
  13 #define CONFIG_SKIP_LOWLEVEL_INIT       /* U-Boot is a 3rd stage loader */
  14 #define CONFIG_SYS_NO_FLASH             /* that is, no *NOR* flash */
  15 #define CONFIG_SYS_CONSOLE_INFO_QUIET
  16
  17 /* SoC Configuration */
  18 #define CONFIG_SYS_TIMERBASE            0x01c21400      /* use timer 0 */
  19 #define CONFIG_SYS_HZ_CLOCK             24000000        /* timer0 freq */
  20 #define CONFIG_SOC_DM365
  21
  22 /* Memory Info */
  23 #define CONFIG_NR_DRAM_BANKS            1
  24 #define PHYS_SDRAM_1                    0x80000000
  25 #define PHYS_SDRAM_1_SIZE               (128 << 20)     /* 128 MiB */
  26
  27 /* Serial Driver info: UART0 for console  */
  28 #define CONFIG_SYS_NS16550
  29 #define CONFIG_SYS_NS16550_SERIAL
  30 #define CONFIG_SYS_NS16550_REG_SIZE     -4
  31 #define CONFIG_SYS_NS16550_COM1         0x01c20000
  32 #define CONFIG_SYS_NS16550_CLK          CONFIG_SYS_HZ_CLOCK
  33 #define CONFIG_CONS_INDEX               1
  34 #define CONFIG_BAUDRATE                 115200
  35
  36 /* EEPROM definitions for EEPROM on DM365 EVM */
  37 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN          2
  38 #define CONFIG_SYS_I2C_EEPROM_ADDR              0x50
  39 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS       6
  40 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS   20
  41
  42 /* Network Configuration */
  43 #define CONFIG_DRIVER_TI_EMAC
  44 #define CONFIG_MII
  45 #define CONFIG_BOOTP_DNS
  46 #define CONFIG_BOOTP_DNS2
  47 #define CONFIG_BOOTP_SEND_HOSTNAME
  48 #define CONFIG_NET_RETRY_COUNT  10
  49
  50 /* I2C */
  51 #define CONFIG_SYS_I2C
  52 #define CONFIG_SYS_I2C_DAVINCI
  53 #define CONFIG_SYS_DAVINCI_I2C_SPEED            400000
  54 #define CONFIG_SYS_DAVINCI_I2C_SLAVE            0x10    /* SMBus host address */
  55
  56 /* NAND: socketed, two chipselects, normally 2 GBytes */
  57 #define CONFIG_NAND_DAVINCI
  58 #define CONFIG_SYS_NAND_CS              2
  59 #define CONFIG_SYS_NAND_USE_FLASH_BBT
  60 #define CONFIG_SYS_NAND_4BIT_HW_ECC_OOBFIRST
  61 #define CONFIG_SYS_NAND_PAGE_2K
  62
  63 #define CONFIG_SYS_NAND_LARGEPAGE
  64 #define CONFIG_SYS_NAND_BASE_LIST       { 0x02000000, }
  65 /* socket has two chipselects, nCE0 gated by address BIT(14) */
  66 #define CONFIG_SYS_MAX_NAND_DEVICE      1
  67 #define CONFIG_SYS_NAND_MAX_CHIPS       2
  68
  69 /* SD/MMC */
  70 #define CONFIG_MMC
  71 #define CONFIG_GENERIC_MMC
  72 #define CONFIG_DAVINCI_MMC
  73 #define CONFIG_DAVINCI_MMC_SD1
  74 #define CONFIG_MMC_MBLOCK
  75
  76 #define PINMUX4_USBDRVBUS_BITCLEAR       0x3000
  77 #define PINMUX4_USBDRVBUS_BITSET         0x2000
  78
  79 /* USB Configuration */
  80 #define CONFIG_USB_DAVINCI
  81 #define CONFIG_MUSB_HCD
  82
  83 #ifdef CONFIG_USB_DAVINCI
  84 #define CONFIG_CMD_USB         /* include support for usb      */
  85 #define CONFIG_CMD_STORAGE     /* include support for usb      */
  86 #define CONFIG_CMD_FAT         /* include support for FAT/storage*/
  87 #define CONFIG_DOS_PARTITION   /* include support for FAT/storage*/
  88 #endif
  89
  90 #ifdef CONFIG_MUSB_HCD         /* include support for usb host */
  91 #define CONFIG_CMD_USB         /* include support for usb cmd */
  92 #define CONFIG_USB_STORAGE     /* MSC class support */
  93 #define CONFIG_CMD_STORAGE     /* inclue support for usb-storage cmd */
  94 #define CONFIG_CMD_FAT         /* inclue support for FAT/storage */
  95 #define CONFIG_DOS_PARTITION   /* inclue support for FAT/storage */
  96
  97 #ifdef CONFIG_USB_KEYBOARD     /* HID class support */
  98 #define CONFIG_SYS_USB_EVENT_POLL
  99
 100 #define CONFIG_PREBOOT "usb start"
 101 #endif /* CONFIG_USB_KEYBOARD */
 102 #endif /* CONFIG_MUSB_HCD */
 103
 104 #ifdef CONFIG_MUSB_UDC
 105 #define CONFIG_USB_DEVICE              1
 106 #define CONFIG_USB_TTY                 1
 107 #define CONFIG_SYS_CONSOLE_IS_IN_ENV   1
 108 #define CONFIG_USBD_VENDORID           0x0451
 109 #define CONFIG_USBD_PRODUCTID          0x5678
 110 #define CONFIG_USBD_MANUFACTURER       "Texas Instruments"
 111 #define CONFIG_USBD_PRODUCT_NAME       "DM365VM"
 112 #endif /* CONFIG_MUSB_UDC */
 113
 114 /* U-Boot command configuration */
 115 #include <config_cmd_default.h>
 116
 117 #undef CONFIG_CMD_BDI
 118 #undef CONFIG_CMD_FLASH
 119 #undef CONFIG_CMD_FPGA
 120 #undef CONFIG_CMD_SETGETDCR
 121
 122 #define CONFIG_CMD_ASKENV
 123 #define CONFIG_CMD_DHCP
 124 #define CONFIG_CMD_I2C
 125 #define CONFIG_CMD_PING
 126 #define CONFIG_CMD_SAVES
 127
 128 #ifdef CONFIG_CMD_BDI
 129 #define CONFIG_CLOCKS
 130 #endif
 131
 132 #ifdef CONFIG_MMC
 133 #define CONFIG_DOS_PARTITION
 134 #define CONFIG_CMD_EXT2
 135 #define CONFIG_CMD_FAT
 136 #define CONFIG_CMD_MMC
 137 #endif
 138
 139 #ifdef CONFIG_NAND_DAVINCI
 140 #define CONFIG_CMD_MTDPARTS
 141 #define CONFIG_MTD_PARTITIONS
 142 #define CONFIG_MTD_DEVICE
 143 #define CONFIG_CMD_NAND
 144 #define CONFIG_CMD_UBI
 145 #define CONFIG_RBTREE
 146 #endif
 147
 148 #define CONFIG_CRC32_VERIFY
 149 #define CONFIG_MX_CYCLIC
 150
 151 /* U-Boot general configuration */
 152 #define CONFIG_BOOTFILE         "uImage"        /* Boot file name */
 153 #define CONFIG_SYS_PROMPT       "DM36x EVM # "  /* Monitor Command Prompt */
 154 #define CONFIG_SYS_CBSIZE       1024            /* Console I/O Buffer Size  */
 155 #define CONFIG_SYS_PBSIZE                       /* Print buffer size */ \
 156                 (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
 157 #define CONFIG_SYS_MAXARGS      16              /* max number of command args */
 158 #define CONFIG_SYS_HUSH_PARSER
 159 #define CONFIG_SYS_LONGHELP
 160
 161 #ifdef CONFIG_NAND_DAVINCI
 162 #define CONFIG_ENV_SIZE         (256 << 10)     /* 256 KiB */
 163 #define CONFIG_ENV_IS_IN_NAND
 164 #define CONFIG_ENV_OFFSET       0x3C0000
 165 #undef CONFIG_ENV_IS_IN_FLASH
 166 #endif
 167
 168 #if defined(CONFIG_MMC) && !defined(CONFIG_ENV_IS_IN_NAND)
 169 #define CONFIG_CMD_ENV
 170 #define CONFIG_ENV_SIZE         (16 << 10)      /* 16 KiB */
 171 #define CONFIG_ENV_OFFSET       (51 << 9)       /* Sector 51 */
 172 #define CONFIG_ENV_IS_IN_MMC
 173 #undef CONFIG_ENV_IS_IN_FLASH
 174 #endif
 175
 176 #define CONFIG_BOOTDELAY        3
 177 #define CONFIG_BOOTCOMMAND \
 178                 "dhcp;bootm"
 179 #define CONFIG_BOOTARGS \
 180                 "console=ttyS0,115200n8 " \
 181                 "root=/dev/mmcblk0p1 rootwait rootfstype=ext3 ro"
 182
 183 #define CONFIG_CMDLINE_EDITING
 184 #define CONFIG_VERSION_VARIABLE
 185 #define CONFIG_TIMESTAMP
 186
 187 /* U-Boot memory configuration */
 188 #define CONFIG_SYS_MALLOC_LEN           (1 << 20)       /* 1 MiB */
 189 #define CONFIG_SYS_MEMTEST_START        0x87000000      /* physical address */
 190 #define CONFIG_SYS_MEMTEST_END          0x88000000      /* test 16MB RAM */
 191
 192 /* Linux interfacing */
 193 #define CONFIG_CMDLINE_TAG
 194 #define CONFIG_SETUP_MEMORY_TAGS
 195 #define CONFIG_SYS_BARGSIZE     1024                    /* bootarg Size */
 196 #define CONFIG_SYS_LOAD_ADDR    0x80700000              /* kernel address */
 197
 198
 199 /* NAND configuration issocketed with two chipselects just like the DM355 EVM.
 200  * It normally comes with a 2GByte SLC part with 2KB pages
 201  * (and 128KB erase blocks); other
 202  * 2GByte parts may have 4KB pages, 256KB erase blocks, and use MLC.  (MLC
 203  * pretty much demands the 4-bit ECC support.)  You can of course swap in
 204  * other parts, including small page ones.
 205  */
 206 #define MTDIDS_DEFAULT          "nand0=davinci_nand.0"
 207
 208 #ifdef CONFIG_SYS_NAND_LARGEPAGE
 209 /*  Use same layout for 128K/256K blocks; allow some bad blocks */
 210 #define PART_BOOT               "2m(bootloader)ro,"
 211 #else
 212 /* Assume 16K erase blocks; allow a few bad ones. */
 213 #define PART_BOOT               "512k(bootloader)ro,"
 214 #endif
 215
 216 #define PART_KERNEL             "4m(kernel),"   /* kernel + initramfs */
 217 #define PART_REST               "-(filesystem)"
 218
 219 #define MTDPARTS_DEFAULT        \
 220         "mtdparts=davinci_nand.0:" PART_BOOT PART_KERNEL PART_REST
 221
 222 #define CONFIG_MAX_RAM_BANK_SIZE        (256 << 20)     /* 256 MB */
 223
 224 #define CONFIG_SYS_SDRAM_BASE           PHYS_SDRAM_1
 225 #define CONFIG_SYS_INIT_SP_ADDR         \
 226         (CONFIG_SYS_SDRAM_BASE + 0x1000 - GENERATED_GBL_DATA_SIZE)
 227
 228 #endif /* __CONFIG_H */