1 // SPDX-License-Identifier: GPL-2.0
3 #include "bcm2837.dtsi"
4 #include "bcm2836-rpi.dtsi"
5 #include "bcm283x-rpi-lan7515.dtsi"
6 #include "bcm283x-rpi-led-deprecated.dtsi"
7 #include "bcm283x-rpi-usb-host.dtsi"
8 #include "bcm283x-rpi-wifi-bt.dtsi"
11 compatible = "raspberrypi,3-model-b-plus", "brcm,bcm2837";
12 model = "Raspberry Pi 3 Model B+";
15 /* 8250 auxiliary UART instead of pl011 */
16 stdout-path = "serial1:115200n8";
20 device_type = "memory";
26 shutdown-gpios = <&expgpio 0 GPIO_ACTIVE_HIGH>;
31 compatible = "raspberrypi,firmware-gpio";
34 gpio-line-names = "BT_ON",
48 * Taken from rpi_SCH_3bplus_1p0_reduced.pdf and
49 * the official GPU firmware DT blob.
52 * "FOO" = GPIO line named "FOO" on the schematic
53 * "FOO_N" = GPIO line named "FOO" on schematic, active low
55 gpio-line-names = "ID_SDA",
86 /* Used by BT module */
106 /* Used by SD Card */
116 hpd-gpios = <&gpio 28 GPIO_ACTIVE_LOW>;
117 power-domains = <&power RPI_POWER_DOMAIN_HDMI>;
122 gpios = <&gpio 29 GPIO_ACTIVE_HIGH>;
128 gpios = <&expgpio 2 GPIO_ACTIVE_LOW>;
129 default-state = "keep";
130 linux,default-trigger = "default-on";
135 pinctrl-names = "default";
136 pinctrl-0 = <&pwm0_gpio40 &pwm1_gpio41>;
140 /* SDHOST is used to drive the SD card */
142 pinctrl-names = "default";
143 pinctrl-0 = <&sdhost_gpio48>;
148 /* uart0 communicates with the BT module */
150 pinctrl-names = "default";
151 pinctrl-0 = <&uart0_ctsrts_gpio30 &uart0_gpio32 &gpclk2_gpio43>;
154 /* uart1 is mapped to the pin header */
156 pinctrl-names = "default";
157 pinctrl-0 = <&uart1_gpio14>;
162 reset-gpios = <&expgpio 1 GPIO_ACTIVE_LOW>;