src/arm64/qcom/pmx75.dtsi

   1 // SPDX-License-Identifier: BSD-3-Clause
   2 /*
   3  * Copyright (c) 2023 Qualcomm Innovation Center, Inc. All rights reserved.
   4  */
   5
   6 #include <dt-bindings/interrupt-controller/irq.h>
   7 #include <dt-bindings/spmi/spmi.h>
   8
   9 / {
  10         thermal-zones {
  11                 pmx75-thermal {
  12                         polling-delay-passive = <100>;
  13                         polling-delay = <0>;
  14
  15                         thermal-sensors = <&pmx75_temp_alarm>;
  16
  17                         trips {
  18                                 trip0 {
  19                                         temperature = <95000>;
  20                                         hysteresis = <0>;
  21                                         type = "passive";
  22                                 };
  23
  24                                 trip1 {
  25                                         temperature = <115000>;
  26                                         hysteresis = <0>;
  27                                         type = "hot";
  28                                 };
  29
  30                                 trip2 {
  31                                         temperature = <145000>;
  32                                         hysteresis = <0>;
  33                                         type = "critical";
  34                                 };
  35                         };
  36                 };
  37         };
  38 };
  39
  40 &spmi_bus {
  41         pmx75: pmic@1 {
  42                 compatible = "qcom,pmx75", "qcom,spmi-pmic";
  43                 reg = <1 SPMI_USID>;
  44                 #address-cells = <1>;
  45                 #size-cells = <0>;
  46
  47                 pmx75_temp_alarm: temp-alarm@a00 {
  48                         compatible = "qcom,spmi-temp-alarm";
  49                         reg = <0xa00>;
  50                         interrupts = <0x1 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
  51                         #thermal-sensor-cells = <0>;
  52                 };
  53
  54                 pmx75_gpios: gpio@8800 {
  55                         compatible = "qcom,pmx75-gpio", "qcom,spmi-gpio";
  56                         reg = <0x8800>;
  57                         gpio-controller;
  58                         gpio-ranges = <&pmx75_gpios 0 0 16>;
  59                         #gpio-cells = <2>;
  60                         interrupt-controller;
  61                         #interrupt-cells = <2>;
  62                 };
  63         };
  64 };