======================================================================
-Changes since U-Boot 1.1.1:
+Changes for U-Boot 1.1.3:
======================================================================
+* Patch by Daniel Poirot, 10 Oct 2004:
+ Add support for Wind River sbc405 board
+
+* Patch by Rainer Brestan, 12 Oct 2004:
+ Make examples/Makefile more robust
+
+* Patch by Sam Song, 11 October 2004:
+ - Add RESET/PREBOOT/AUTOBOOT support for RPXlite_DW board
+ - Adjust CPU:BUS frequency ratio 1:1 when core frequency
+ less than 50MHz
+
+* Patch by Sam Song, 10 Oct 2004:
+ Fix a parameter error in run_command() in main.c
+
+* Patch by Richard Woodruff, 01 Oct 2004:
+ add support for the TI OMAP2420 processor and its H4 reference
+ board
+
+* Patch by Christian Pellegrin, 24 Sep 2004:
+ Added support for NE2000 compatible (DP8390, DP83902) NICs.
+
+* Patch by Leif Lindholm, 23 Sep 2004:
+ add support for the AMD db1550 board
+
+* Patch by Travis Sawyer, 15 Sep 2004:
+ Add CONFIG_SERIAL_MULTI support for ppc4xx,
+ update README.serial_multi
+
+* Patches by David Snowdon, 07 Sep 2004:
+ - add u-boot.hex target in the top level Makefile
+ - add support for the UNSW/NICTA PLEB 2 board (pleb2)
+ - use -mtune=xscale and -march=armv5 options for PXA
+
+* Patch by Florian Schlote, 08 Sep 2004:
+ Add support for SenTec-COBRA5272-board (Coldfire).
+
+* Patch by Gleb Natapov, 07 Sep 2004:
+ mpc824x: set PCI latency timer to a sane value
+ (is 0 after reset).
+
+* Patch by Kurt Stremerch, 03 Sep 2004:
+ Add bitstream configuration option for fpga command (Xilinx only).
+
+* Patch by Kurt Stremerch, 03 Sep 2004:
+ Add Xilinx Spartan2E family FPGA support
+
+* Patch by Jeff Angielski, 02 Sep 2004:
+ Add Added support for H2 revision of the EP8260 board.
+ Fixed formatting for some of the EP8260 related source files.
+
+* Patch by Jon Loeliger, 02 Sep 2004:
+ Reset monitor size back to 256 so environment can be written
+ to flash on MPC85xx ADS and CDS releases.
+
+* Patch by Paolo Broggini, 02 Sep 2004:
+ Make BSS clearing on ARM systems more robust
+
+* Patch by Yue Hu and Joe, 01 Sep 2004:
+ - add PCI support for ixp425;
+ - add EEPRO100 suppor tfor ixdp425 board.
+
+* Fix problem with protected sector detection in driver/cfi_flash.c
+
+======================================================================
+Changes for U-Boot 1.1.2:
+======================================================================
+
+* Code cleanup, mostly for GCC-3.3.x
+
+* Cleanup confusing use of CONFIG_ETH*ADDR - ust his only to
+ pre-define a MAC address; use CONFIG_HAS_ETH* to enable support for
+ additional ethernet addresses.
+
+* Cleanup drivers/i82365.c - avoid duplication of code
+
+* Fix bogus "cannot span across banks" flash error message
+
+* Code cleanup
+
+* Add support for CompactFlash for the CPC45 Board.
+
+* Fix problems with CMC_PU2 flash driver.
+
+* Cleanup:
+ - avoid trigraph warning in fs/ext2/ext2fs.c
+ - rename UC100 -> uc100
+
+* Add support for UC100 board
+
+* Patch by Stefan Roese, 16 Dez 2004:
+ - ext2fs support added
+ - Tundra universe support added
+ - Coldfire MCF5249 support added (no preloader needed!)
+ - MCF5249 board TASREG added
+ - PPC boards added: APC405, CPCI405DT, CPCI750, G2000, HH405,
+ VOM405, WUH405
+ - some esd boards updated
+ - memory commands "mdc" and "mwc" added for cyclic read/write
+ (CONFIG_MX_CYCLIC, see README for further description)
+
+* Add support for INKA4X0 board
+
+* Patch by Steven Scholz, 12 Dec 2004:
+ Fix typo in AT91 memory setup.
+
+* Patch by Martin Krause, 27 Oct 2004:
+ - add support for "STK52xx" board (including PS/2 multiplexer)
+ - add hardware detection for TQM5200
+
* Clean up CMC PU2 flash driver
* Update MAINTAINERS file