9 i2c buses for Exynos4 and 1 for S3C24X0 SoCs from Samsung)
with a fix speed from 100000 and the slave addr 0!
+ - drivers/i2c/ihs_i2c.c
+ - activate this driver with CONFIG_SYS_I2C_IHS
+ - CONFIG_SYS_I2C_IHS_CH0 activate hardware channel 0
+ - CONFIG_SYS_I2C_IHS_SPEED_0 speed channel 0
+ - CONFIG_SYS_I2C_IHS_SLAVE_0 slave addr channel 0
+ - CONFIG_SYS_I2C_IHS_CH1 activate hardware channel 1
+ - CONFIG_SYS_I2C_IHS_SPEED_1 speed channel 1
+ - CONFIG_SYS_I2C_IHS_SLAVE_1 slave addr channel 1
+ - CONFIG_SYS_I2C_IHS_CH2 activate hardware channel 2
+ - CONFIG_SYS_I2C_IHS_SPEED_2 speed channel 2
+ - CONFIG_SYS_I2C_IHS_SLAVE_2 slave addr channel 2
+ - CONFIG_SYS_I2C_IHS_CH3 activate hardware channel 3
+ - CONFIG_SYS_I2C_IHS_SPEED_3 speed channel 3
+ - CONFIG_SYS_I2C_IHS_SLAVE_3 slave addr channel 3
+
additional defines:
CONFIG_SYS_NUM_I2C_BUSES
disabled. If a board need legacy image format support
enable this through CONFIG_IMAGE_FORMAT_LEGACY
+ CONFIG_FIT_DISABLE_SHA256
+ Supporting SHA256 hashes has quite an impact on binary size.
+ For constrained systems sha256 hash support can be disabled
+ with this option.
+
- Standalone program support:
CONFIG_STANDALONE_LOAD_ADDR
environment area within the total memory of your DataFlash placed
at the specified address.
+- CONFIG_ENV_IS_IN_SPI_FLASH:
+
+ Define this if you have a SPI Flash memory device which you
+ want to use for the environment.
+
+ - CONFIG_ENV_OFFSET:
+ - CONFIG_ENV_SIZE:
+
+ These two #defines specify the offset and size of the
+ environment area within the SPI Flash. CONFIG_ENV_OFFSET must be
+ aligned to an erase sector boundary.
+
+ - CONFIG_ENV_SECT_SIZE:
+
+ Define the SPI flash's sector size.
+
+ - CONFIG_ENV_OFFSET_REDUND (optional):
+
+ This setting describes a second storage area of CONFIG_ENV_SIZE
+ size used to hold a redundant copy of the environment data, so
+ that there is a valid backup copy in case there is a power failure
+ during a "saveenv" operation. CONFIG_ENV_OFFSET_RENDUND must be
+ aligned to an erase sector boundary.
+
+ - CONFIG_ENV_SPI_BUS (optional):
+ - CONFIG_ENV_SPI_CS (optional):
+
+ Define the SPI bus and chip select. If not defined they will be 0.
+
+ - CONFIG_ENV_SPI_MAX_HZ (optional):
+
+ Define the SPI max work clock. If not defined then use 1MHz.
+
+ - CONFIG_ENV_SPI_MODE (optional):
+
+ Define the SPI work mode. If not defined then use SPI_MODE_3.
+
- CONFIG_ENV_IS_IN_REMOTE:
Define this if you have a remote memory space which you