ARM: dts: sun8i: a23/a33: Remove card detect pull-up

[thirdparty/linux.git] / arch / arm / boot / dts / sun8i-a23-evb.dts

diff --git a/arch/arm/boot/dts/sun8i-a23-evb.dts b/arch/arm/boot/dts/sun8i-a23-evb.dts
index b6aeb23b6ee9989f3387665503a13b6145f2b82e..3c994df0ffdf31697ff723ec664d5fa3dfaaaa5b 100644 (file)
--- a/arch/arm/boot/dts/sun8i-a23-evb.dts
+++ b/arch/arm/boot/dts/sun8i-a23-evb.dts
@@ -104,21 +104,13 @@
 
 &mmc0 {
        pinctrl-names = "default";
-       pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_evb>;
+       pinctrl-0 = <&mmc0_pins_a>;
        vmmc-supply = <&reg_vcc3v0>;
        bus-width = <4>;
        cd-gpios = <&pio 1 4 GPIO_ACTIVE_LOW>; /* PB4 */
        status = "okay";
 };
 
-&pio {
-       mmc0_cd_pin_evb: mmc0_cd_pin@0 {
-               pins = "PB4";
-               function = "gpio_in";
-               bias-pull-up;
-       };
-};
-
 /*
  * The RX line has a non-populated resistance. In order to use it, you
  * need to solder R207 on the back of the board in order to close the