+/* SPDX-License-Identifier: GPL-2.0+ */
/*
* (C) Copyright 2002-2010
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#ifndef __ASM_GBL_DATA_H
#endif
/* "static data" needed by most of timer.c on ARM platforms */
unsigned long timer_rate_hz;
- unsigned long tbu;
- unsigned long tbl;
+ unsigned int tbu;
+ unsigned int tbl;
unsigned long lastinc;
unsigned long long timer_reset_value;
-#if !(defined(CONFIG_SYS_ICACHE_OFF) && defined(CONFIG_SYS_DCACHE_OFF))
+#if !(CONFIG_IS_ENABLED(SYS_ICACHE_OFF) && CONFIG_IS_ENABLED(SYS_DCACHE_OFF))
unsigned long tlb_addr;
unsigned long tlb_size;
+#if defined(CONFIG_ARM64)
+ unsigned long tlb_fillptr;
+ unsigned long tlb_emerg;
+#endif
+#endif
+#ifdef CONFIG_SYS_MEM_RESERVE_SECURE
+#define MEM_RESERVE_SECURE_SECURED 0x1
+#define MEM_RESERVE_SECURE_MAINTAINED 0x2
+#define MEM_RESERVE_SECURE_ADDR_MASK (~0x3)
+ /*
+ * Secure memory addr
+ * This variable needs maintenance if the RAM base is not zero,
+ * or if RAM splits into non-consecutive banks. It also has a
+ * flag indicating the secure memory is marked as secure by MMU.
+ * Flags used: 0x1 secured
+ * 0x2 maintained
+ */
+ phys_addr_t secure_ram;
+ unsigned long tlb_allocated;
+#endif
+#ifdef CONFIG_RESV_RAM
+ /*
+ * Reserved RAM for memory resident, eg. Management Complex (MC)
+ * driver which continues to run after U-Boot exits.
+ */
+ phys_addr_t resv_ram;
#endif
-#ifdef CONFIG_OMAP_COMMON
+#ifdef CONFIG_ARCH_OMAP2PLUS
u32 omap_boot_device;
u32 omap_boot_mode;
u8 omap_ch_flags;
#if defined(CONFIG_FSL_LSCH3) && defined(CONFIG_SYS_FSL_HAS_DP_DDR)
unsigned long mem2_clk;
#endif
+
+#ifdef CONFIG_ARCH_IMX8
+ struct udevice *scu_dev;
+#endif
};
#include <asm-generic/global_data.h>