config TARGET_QEMU_MIPS
bool "Support qemu-mips"
+ select SUPPORTS_BIG_ENDIAN
+ select SUPPORTS_LITTLE_ENDIAN
config TARGET_MALTA
bool "Support malta"
+ select SUPPORTS_BIG_ENDIAN
+ select SUPPORTS_LITTLE_ENDIAN
config TARGET_VCT
bool "Support vct"
+ select SUPPORTS_BIG_ENDIAN
config TARGET_DBAU1X00
bool "Support dbau1x00"
+ select SUPPORTS_BIG_ENDIAN
+ select SUPPORTS_LITTLE_ENDIAN
config TARGET_PB1X00
bool "Support pb1x00"
+ select SUPPORTS_LITTLE_ENDIAN
config TARGET_QEMU_MIPS64
bool "Support qemu-mips64"
+ select SUPPORTS_BIG_ENDIAN
+ select SUPPORTS_LITTLE_ENDIAN
endchoice
source "board/pb1x00/Kconfig"
source "board/qemu-mips/Kconfig"
+if MIPS
+
+choice
+ prompt "Endianness selection"
+ help
+ Some MIPS boards can be configured for either little or big endian
+ byte order. These modes require different U-Boot images. In general there
+ is one preferred byteorder for a particular system but some systems are
+ just as commonly used in the one or the other endianness.
+
+config SYS_BIG_ENDIAN
+ bool "Big endian"
+ depends on SUPPORTS_BIG_ENDIAN
+
+config SYS_LITTLE_ENDIAN
+ bool "Little endian"
+ depends on SUPPORTS_LITTLE_ENDIAN
+
+endchoice
+
+config SUPPORTS_BIG_ENDIAN
+ bool
+
+config SUPPORTS_LITTLE_ENDIAN
+ bool
+
+endif
+
endmenu