default "mips32" if CPU_MIPS32_R1 || CPU_MIPS32_R2
default "mips64" if CPU_MIPS64_R1 || CPU_MIPS64_R2
-config USE_PRIVATE_LIBGCC
- default y
-
choice
prompt "Target select"
+ optional
config TARGET_QEMU_MIPS
bool "Support qemu-mips"
config TARGET_MALTA
bool "Support malta"
+ select DYNAMIC_IO_PORT_BASE
select SUPPORTS_BIG_ENDIAN
select SUPPORTS_LITTLE_ENDIAN
select SUPPORTS_CPU_MIPS32_R1
select SUPPORTS_CPU_MIPS32_R2
select SWAP_IO_SPACE
+ select MIPS_L1_CACHE_SHIFT_6
config TARGET_VCT
bool "Support vct"
select SUPPORTS_CPU_MIPS32_R1
select SUPPORTS_CPU_MIPS32_R2
select SYS_MIPS_CACHE_INIT_RAM_LOAD
+ select MIPS_TUNE_4KC
config TARGET_PB1X00
bool "Support pb1x00"
select SUPPORTS_CPU_MIPS32_R1
select SUPPORTS_CPU_MIPS32_R2
select SYS_MIPS_CACHE_INIT_RAM_LOAD
+ select MIPS_TUNE_4KC
+config MACH_PIC32
+ bool "Support Microchip PIC32"
+ select OF_CONTROL
+ select DM
endchoice
source "board/micronas/vct/Kconfig"
source "board/pb1x00/Kconfig"
source "board/qemu-mips/Kconfig"
+source "arch/mips/mach-pic32/Kconfig"
if MIPS
The address of the enviroment is stored in register $a2.
config MIPS_BOOT_FDT
- bool "Hand over a flattened device tree to Linux kernel (INCOMPLETE)"
+ bool "Hand over a flattened device tree to Linux kernel"
default n
help
Enable this option if you want U-Boot to hand over a flattened
- device tree to the kernel.
-
- Note: the final hand over to the kernel is not yet implemented. After
- the community agreed on the MIPS boot interface for device trees,
- the corresponding code will be added.
+ device tree to the kernel. According to UHI register $a0 will be set
+ to -2 and the FDT address is stored in $a1.
endmenu
bool
default y if CPU_MIPS64_R1 || CPU_MIPS64_R2
+config MIPS_TUNE_4KC
+ bool
+
+config MIPS_TUNE_14KC
+ bool
+
+config MIPS_TUNE_24KC
+ bool
+
config 32BIT
bool
config SYS_MIPS_CACHE_INIT_RAM_LOAD
bool
+config MIPS_L1_CACHE_SHIFT_4
+ bool
+
+config MIPS_L1_CACHE_SHIFT_5
+ bool
+
+config MIPS_L1_CACHE_SHIFT_6
+ bool
+
+config MIPS_L1_CACHE_SHIFT_7
+ bool
+
+config MIPS_L1_CACHE_SHIFT
+ int
+ default "7" if MIPS_L1_CACHE_SHIFT_7
+ default "6" if MIPS_L1_CACHE_SHIFT_6
+ default "5" if MIPS_L1_CACHE_SHIFT_5
+ default "4" if MIPS_L1_CACHE_SHIFT_4
+ default "5"
+
+config DYNAMIC_IO_PORT_BASE
+ bool
+
endif
endmenu