*
* There is one NAND devices on the board, a Hynix HY27US08561A (32 MByte).
*/
-static void pdnb3_nand_hwcontrol(struct mtd_info *mtd, int cmd)
+static void pdnb3_nand_hwcontrol(struct mtd_info *mtd, int cmd, unsigned int ctrl)
{
- switch (cmd) {
- case NAND_CTL_SETCLE:
- hwctl |= 0x1;
- break;
- case NAND_CTL_CLRCLE:
- hwctl &= ~0x1;
- break;
-
- case NAND_CTL_SETALE:
- hwctl |= 0x2;
- break;
- case NAND_CTL_CLRALE:
- hwctl &= ~0x2;
- break;
-
- case NAND_CTL_SETNCE:
- break;
- case NAND_CTL_CLRNCE:
- writeb(0x00, &(pdnb3_ndfc->term));
- break;
+ struct nand_chip *this = mtd->priv;
+
+ if (ctrl & NAND_CTRL_CHANGE) {
+ if ( ctrl & NAND_CLE )
+ hwctl |= 0x1;
+ else
+ hwctl &= ~0x1;
+ if ( ctrl & NAND_ALE )
+ hwctl |= 0x2;
+ else
+ hwctl &= ~0x2;
+ if ( (ctrl & NAND_NCE) != NAND_NCE)
+ writeb(0x00, &(pdnb3_ndfc->term));
}
+ if (cmd != NAND_CMD_NONE)
+ writeb(cmd, this->IO_ADDR_W);
}
-static void pdnb3_nand_write_byte(struct mtd_info *mtd, u_char byte)
-{
- if (hwctl & 0x1)
- writeb(byte, &(pdnb3_ndfc->cmd));
- else if (hwctl & 0x2)
- writeb(byte, &(pdnb3_ndfc->addr));
- else
- writeb(byte, &(pdnb3_ndfc->data));
-}
static u_char pdnb3_nand_read_byte(struct mtd_info *mtd)
{
int board_nand_init(struct nand_chip *nand)
{
- pdnb3_ndfc = (struct pdnb3_ndfc_regs *)CFG_NAND_BASE;
+ pdnb3_ndfc = (struct pdnb3_ndfc_regs *)CONFIG_SYS_NAND_BASE;
- nand->eccmode = NAND_ECC_SOFT;
+ nand->ecc.mode = NAND_ECC_SOFT;
/* Set address of NAND IO lines (Using Linear Data Access Region) */
nand->IO_ADDR_R = (void __iomem *) ((ulong) pdnb3_ndfc + 0x4);
nand->IO_ADDR_W = (void __iomem *) ((ulong) pdnb3_ndfc + 0x4);
/* Reference hardware control function */
- nand->hwcontrol = pdnb3_nand_hwcontrol;
- /* Set command delay time */
- nand->hwcontrol = pdnb3_nand_hwcontrol;
- nand->write_byte = pdnb3_nand_write_byte;
+ nand->cmd_ctrl = pdnb3_nand_hwcontrol;
nand->read_byte = pdnb3_nand_read_byte;
nand->write_buf = pdnb3_nand_write_buf;
nand->read_buf = pdnb3_nand_read_buf;