drivers/mtd: Move conditional compilation to Makefile

[people/ms/u-boot.git] / include / configs / M54455EVB.h

diff --git a/include/configs/M54455EVB.h b/include/configs/M54455EVB.h
index 211f11d604633737e99d2dc5184b4b08df12d075..6620f03d3d66c8d902fa47931b770638d2e9912a 100644 (file)
--- a/include/configs/M54455EVB.h
+++ b/include/configs/M54455EVB.h
@@ -38,8 +38,6 @@
 #define CONFIG_M54455          /* define processor type */
 #define CONFIG_M54455EVB       /* M54455EVB board */
 
-#undef DEBUG
-
 #define CONFIG_MCFUART
 #define CFG_UART_PORT          (0)
 #define CONFIG_BAUDRATE                115200
@@ -85,9 +83,9 @@
 /* Network configuration */
 #define CONFIG_MCFFEC
 #ifdef CONFIG_MCFFEC
-#      define CONFIG_NET_MULTI 1
+#      define CONFIG_NET_MULTI         1
 #      define CONFIG_MII               1
-#      define CONFIG_CF_DOMII
+#      define CONFIG_MII_INIT          1
 #      define CFG_DISCOVER_PHY
 #      define CFG_RX_ETH_BUFFER        8
 #      define CFG_FAULT_ECHO_LINK_DOWN
@@ -173,9 +171,17 @@
 #define CFG_I2C_OFFSET         0x58000
 #define CFG_IMMR               CFG_MBAR
 
+/* DSPI and Serial Flash */
+#define CONFIG_CF_DSPI
+#define CONFIG_SERIAL_FLASH
+
 /* PCI */
 #ifdef CONFIG_CMD_PCI
 #define CONFIG_PCI             1
+#define CONFIG_PCI_PNP         1
+#define CONFIG_PCIAUTO_SKIP_HOST_BRIDGE        1
+
+#define CFG_PCI_CACHE_LINE_SIZE        4
 
 #define CFG_PCI_MEM_BUS                0xA0000000
 #define CFG_PCI_MEM_PHYS       CFG_PCI_MEM_BUS
@@ -192,9 +198,7 @@
 
 /* FPGA - Spartan 2 */
 /* experiment
-#define CONFIG_FPGA
-#define CONFIG_FPGA_XILINX
-#define CONFIG_FPGA_SPARTAN3
+#define CONFIG_FPGA            CFG_SPARTAN3
 #define CONFIG_FPGA_COUNT      1
 #define CFG_FPGA_PROG_FEEDBACK
 #define CFG_FPGA_CHECK_CTRLC
@@ -286,9 +290,9 @@
 #      define CFG_ENV_ADDR             (CFG_FLASH_BASE + 0x4000)
 #      define CFG_ENV_SECT_SIZE        0x2000
 #else
-#      define CFG_FLASH_BASE           CFG_FLASH0_BASE
-#      define CFG_FLASH0_BASE          CFG_CS1_BASE
-#      define CFG_FLASH1_BASE          CFG_CS0_BASE
+#      define CFG_FLASH_BASE           CFG_CS0_BASE
+#      define CFG_FLASH0_BASE          CFG_CS0_BASE
+#      define CFG_FLASH1_BASE          CFG_CS1_BASE
 #      define CFG_ENV_ADDR             (CFG_FLASH_BASE + 0x60000)
 #      define CFG_ENV_SECT_SIZE        0x20000
 #endif
@@ -298,7 +302,7 @@
 #undef CFG_FLASH_CFI
 #ifdef CFG_FLASH_CFI
 
-#      define CFG_FLASH_CFI_DRIVER     1
+#      define CONFIG_FLASH_CFI_DRIVER  1
 #      define CFG_FLASH_SIZE           0x1000000       /* Max size that the board might have */
 #      define CFG_FLASH_CFI_WIDTH      FLASH_CFI_8BIT
 #      define CFG_MAX_FLASH_BANKS      2       /* max number of memory banks */
@@ -309,7 +313,7 @@
 
 #else
 
-#      define CFG_MAX_FLASH_BANKS      2       /* max number of memory banks */
+#      define CFG_MAX_FLASH_BANKS      3       /* max number of memory banks */
 
 #      define CFG_ATMEL_REGION         4
 #      define CFG_ATMEL_TOTALSECT      11
@@ -326,6 +330,28 @@
 #      define CFG_FLASH_PROTECTION     /* "Real" (hardware) sectors protection */
 #      define CFG_FLASH_CHECKSUM
 
+#ifdef CONFIG_SERIAL_FLASH
+#      define CFG_FLASH2_BASE          0x01000000
+#      define CFG_STM_SECT             32
+#      define CFG_STM_SECTSZ           0x10000
+
+#      undef CFG_FLASH_ERASE_TOUT
+#      define CFG_FLASH_ERASE_TOUT     20000
+
+#      define SER_WREN                 0x06
+#      define SER_WRDI                 0x04
+#      define SER_RDID                 0x9F
+#      define SER_RDSR                 0x05
+#      define SER_WRSR                 0x01
+#      define SER_READ                 0x03
+#      define SER_F_READ               0x0B
+#      define SER_PAGE_PROG            0x02
+#      define SER_SECT_ERASE           0xD8
+#      define SER_BULK_ERASE           0xC7
+#      define SER_DEEP_PWRDN           0xB9
+#      define SER_RES                  0xAB
+#endif
+
 #endif
 
 /*