Merge git://www.denx.de/git/u-boot-imx

[people/ms/u-boot.git] / include / configs / MPC8641HPCN.h

diff --git a/include/configs/MPC8641HPCN.h b/include/configs/MPC8641HPCN.h
index b35bbd4eb881b3956808560096dffd9408cd6f6d..94483b5fa16cd9b28dff81244c0ae5dd3a168591 100644 (file)
--- a/include/configs/MPC8641HPCN.h
+++ b/include/configs/MPC8641HPCN.h
@@ -17,8 +17,6 @@
 #define __CONFIG_H
 
 /* High Level Configuration Options */
-#define CONFIG_MPC8641         1       /* MPC8641 specific */
-#define CONFIG_MPC8641HPCN     1       /* MPC8641HPCN board specific */
 #define CONFIG_MP              1       /* support multiple processors */
 #define CONFIG_LINUX_RESET_VEC 0x100   /* Reset vector used by Linux */
 #define CONFIG_ADDR_MAP                1       /* Use addr map */
@@ -46,7 +44,6 @@
 #define CONFIG_PCIE2           1       /* PCIE controller 2 (slot) */
 #define CONFIG_FSL_PCI_INIT    1       /* Use common FSL init code */
 #define CONFIG_SYS_PCI_64BIT   1       /* enable 64-bit PCI resources */
-#define CONFIG_FSL_LAW         1       /* Use common FSL law init code */
 
 #define CONFIG_TSEC_ENET               /* tsec ethernet support */
 #define CONFIG_ENV_OVERWRITE
@@ -89,7 +86,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  * Base addresses -- Note these are effective addresses where the
  * actual resources get mapped (not physical addresses)
  */
-#define CONFIG_SYS_CCSRBAR_DEFAULT     0xff700000      /* CCSRBAR Default */
 #define CONFIG_SYS_CCSRBAR             0xffe00000      /* relocated CCSRBAR */
 #define CONFIG_SYS_IMMR                CONFIG_SYS_CCSRBAR      /* PQII uses CONFIG_SYS_IMMR */
 
@@ -105,8 +101,7 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 /*
  * DDR Setup
  */
-#define CONFIG_SYS_FSL_DDR2
-#undef CONFIG_FSL_DDR_INTERACTIVE
+#define CONFIG_FSL_DDR_INTERACTIVE
 #define CONFIG_SPD_EEPROM              /* Use SPD EEPROM for DDR setup */
 #define CONFIG_DDR_SPD
 
@@ -118,7 +113,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_SYS_MAX_DDR_BAT_SIZE    0x80000000      /* BAT mapping size */
 #define CONFIG_VERY_BIG_RAM
 
-#define CONFIG_NUM_DDR_CONTROLLERS     2
 #define CONFIG_DIMM_SLOTS_PER_CTLR     2
 #define CONFIG_CHIP_SELECTS_PER_CTRL   (2 * CONFIG_DIMM_SLOTS_PER_CTLR)
 
@@ -380,7 +374,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 
 #undef CONFIG_PCI_SCAN_SHOW            /* show pci devices on startup */
 
-#define CONFIG_DOS_PARTITION
 #define CONFIG_SCSI_AHCI
 
 #ifdef CONFIG_SCSI_AHCI
@@ -570,12 +563,10 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
  * Environment
  */
 #ifndef CONFIG_SYS_RAMBOOT
-    #define CONFIG_ENV_IS_IN_FLASH     1
     #define CONFIG_ENV_ADDR            \
                        (CONFIG_SYS_MONITOR_BASE + CONFIG_SYS_MONITOR_LEN)
     #define CONFIG_ENV_SECT_SIZE               0x10000 /* 64K(one sector) for env */
 #else
-    #define CONFIG_ENV_IS_NOWHERE      1       /* Store ENV in memory only */
     #define CONFIG_ENV_ADDR            (CONFIG_SYS_MONITOR_BASE - 0x1000)
 #endif
 #define CONFIG_ENV_SIZE                0x2000
@@ -591,16 +582,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 #define CONFIG_BOOTP_GATEWAY
 #define CONFIG_BOOTP_HOSTNAME
 
-/*
- * Command line configuration.
- */
-#define CONFIG_CMD_REGINFO
-
-#if defined(CONFIG_PCI)
-    #define CONFIG_CMD_PCI
-    #define CONFIG_SCSI
-#endif
-
 #undef CONFIG_WATCHDOG                 /* watchdog disabled */
 
 /*
@@ -655,10 +636,6 @@ extern unsigned long get_board_sys_clk(unsigned long dummy);
 /* default location for tftp and bootm */
 #define CONFIG_LOADADDR                0x10000000
 
-#undef CONFIG_BOOTARGS         /* the boot command will set bootargs */
-
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                                       \
        "netdev=eth0\0"                                                 \
        "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"                     \