pwm: lpc32xx: Don't modify HW state in .probe() after the PWM chip was registered

This fixes a race condition: After pwmchip_add() is called there might
already be a consumer and then modifying the hardware behind the
consumer's back is bad. So set the default before.

(Side-note: I don't know what this register setting actually does, if
this modifies the polarity there is an inconsistency because the
inversed polarity isn't considered if the PWM is already running during
.probe().)

Fixes: acfd92fdfb93 ("pwm: lpc32xx: Set PWM_PIN_LEVEL bit to default value")
Cc: Sylvain Lemieux <slemieux@tycoint.com>
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Thierry Reding <thierry.reding@gmail.com>

diff --git a/drivers/pwm/pwm-lpc32xx.c b/drivers/pwm/pwm-lpc32xx.c
index 2834a0f001d3a8144be50f04f27d7b608696b7d7..719e8e91365692cb1dc368faea1f61ae1b54f1f3 100644 (file)
--- a/drivers/pwm/pwm-lpc32xx.c
+++ b/drivers/pwm/pwm-lpc32xx.c
@@ -117,17 +117,17 @@ static int lpc32xx_pwm_probe(struct platform_device *pdev)
        lpc32xx->chip.ops = &lpc32xx_pwm_ops;
        lpc32xx->chip.npwm = 1;
 
+       /* If PWM is disabled, configure the output to the default value */
+       val = readl(lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));
+       val &= ~PWM_PIN_LEVEL;
+       writel(val, lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));
+
        ret = pwmchip_add(&lpc32xx->chip);
        if (ret < 0) {
                dev_err(&pdev->dev, "failed to add PWM chip, error %d\n", ret);
                return ret;
        }
 
-       /* When PWM is disable, configure the output to the default value */
-       val = readl(lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));
-       val &= ~PWM_PIN_LEVEL;
-       writel(val, lpc32xx->base + (lpc32xx->chip.pwms[0].hwpwm << 2));
-
        platform_set_drvdata(pdev, lpc32xx);
 
        return 0;