arm64: dts: ti: k3-j721e-sk: Fix pinmux for pin Y1 used by power regulator

The SoC pin Y1 is incorrectly defined in the WKUP Pinmux device-tree node
(pinctrl@4301c000) leading to the following silent failure:

    pinctrl-single 4301c000.pinctrl: mux offset out of range: 0x1dc (0x178)

According to the datasheet for the J721E SoC [0], the pin Y1 belongs to the
MAIN Pinmux device-tree node (pinctrl@11c000). This is confirmed by the
address of the pinmux register for it on page 142 of the datasheet which is
0x00011C1DC.

Hence fix it.

[0]: https://www.ti.com/lit/ds/symlink/tda4vm.pdf

Fixes: 97b67cc102dc ("arm64: dts: ti: k3-j721e-sk: Add DT nodes for power regulators")
Cc: stable@vger.kernel.org
Signed-off-by: Siddharth Vadapalli <s-vadapalli@ti.com>
Reviewed-by: Yemike Abhilash Chandra <y-abhilashchandra@ti.com>
Link: https://patch.msgid.link/20251119160148.2752616-1-s-vadapalli@ti.com
Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>

diff --git a/arch/arm64/boot/dts/ti/k3-j721e-sk.dts b/arch/arm64/boot/dts/ti/k3-j721e-sk.dts
index 542eabfb48dbbd1174c0f237ca755672676f48df..050776cb4df8fefb03afeb579e8c152ce600ea58 100644 (file)
--- a/arch/arm64/boot/dts/ti/k3-j721e-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721e-sk.dts
@@ -474,6 +474,12 @@
                        J721E_IOPAD(0x234, PIN_INPUT, 7) /* (U3) EXT_REFCLK1.GPIO1_12 */
                >;
        };
+
+       vdd_sd_dv_pins_default: vdd-sd-dv-default-pins {
+               pinctrl-single,pins = <
+                       J721E_IOPAD(0x1dc, PIN_OUTPUT, 7) /* (Y1) SPI1_CLK.GPIO0_118 */
+               >;
+       };
 };
 
 &wkup_pmx0 {
@@ -536,12 +542,6 @@
                >;
        };
 
-       vdd_sd_dv_pins_default: vdd-sd-dv-default-pins {
-               pinctrl-single,pins = <
-                       J721E_IOPAD(0x1dc, PIN_OUTPUT, 7) /* (Y1) SPI1_CLK.GPIO0_118 */
-               >;
-       };
-
        wkup_uart0_pins_default: wkup-uart0-default-pins {
                pinctrl-single,pins = <
                        J721E_WKUP_IOPAD(0xa0, PIN_INPUT, 0) /* (J29) WKUP_UART0_RXD */