This fixes an issue where a driver using the deprecated set_ieee8021x()
callback did not include rsn_pairwise bits in the driver configuration
even if mixed WPA+WPA2 configuration was used. This could result, e.g.,
in CCMP not being enabled properly when wpa_pairwise=TKIP and
rsn_pairwise=CCMP was used in the configuration. Fix this by using
bitwise OR of the wpa_pairwise and rsn_pairwise values to allow the
driver to enable all pairwise ciphers.
In addition, make the newer set_ap() driver_ops use the same bitwise OR
design instead of picking between rsn_pairwise and wpa_pairwise. This
makes the code paths consistent and can also fix issues with mixed mode
configuration with set_ap().
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
params.wpa = hapd->conf->wpa;
params.ieee802_1x = hapd->conf->ieee802_1x;
params.wpa_group = hapd->conf->wpa_group;
- params.wpa_pairwise = hapd->conf->wpa_pairwise;
+ params.wpa_pairwise = hapd->conf->wpa_pairwise |
+ hapd->conf->rsn_pairwise;
params.wpa_key_mgmt = hapd->conf->wpa_key_mgmt;
params.rsn_preauth = hapd->conf->rsn_preauth;
#ifdef CONFIG_IEEE80211W
params->basic_rates = hapd->iface->basic_rates;
params->ssid = hapd->conf->ssid.ssid;
params->ssid_len = hapd->conf->ssid.ssid_len;
- params->pairwise_ciphers = hapd->conf->rsn_pairwise ?
- hapd->conf->rsn_pairwise : hapd->conf->wpa_pairwise;
+ params->pairwise_ciphers = hapd->conf->wpa_pairwise |
+ hapd->conf->rsn_pairwise;
params->group_cipher = hapd->conf->wpa_group;
params->key_mgmt_suites = hapd->conf->wpa_key_mgmt;
params->auth_algs = hapd->conf->auth_algs;