spi: airoha: reduce the number of modification of REG_SPI_NFI_CNFG and REG_SPI_NFI_SE...

This just reduce the number of modification of REG_SPI_NFI_CNFG and
REG_SPI_NFI_SECCUS_SIZE registers during dirmap operation.

This patch is a necessary step to avoid usage of flash specific
parameters.

Signed-off-by: Mikhail Kshevetskiy <mikhail.kshevetskiy@iopsys.eu>

diff --git a/drivers/spi/airoha_snfi_spi.c b/drivers/spi/airoha_snfi_spi.c
index b136f8b26d24f3c8282897eb750c63336925700f..55194648d9cc5c2506b952d5f272f5721f1765df 100644 (file)
--- a/drivers/spi/airoha_snfi_spi.c
+++ b/drivers/spi/airoha_snfi_spi.c
@@ -645,7 +645,48 @@ static ssize_t airoha_snand_dirmap_read(struct spi_mem_dirmap_desc *desc,
        if (err < 0)
                return err;
 
-       err = airoha_snand_nfi_config(priv);
+       /* NFI reset */
+       err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CON,
+                          SPI_NFI_FIFO_FLUSH | SPI_NFI_RST);
+       if (err)
+               goto error_dma_mode_off;
+
+       /* NFI configure:
+        *   - No AutoFDM (custom sector size (SECCUS) register will be used)
+        *   - No SoC's hardware ECC (flash internal ECC will be used)
+        *   - Use burst mode (faster, but requires 16 byte alignment for addresses)
+        *   - Setup for reading (SPI_NFI_READ_MODE)
+        *   - Setup reading command: FIELD_PREP(SPI_NFI_OPMODE, 6)
+        *   - Use DMA instead of PIO for data reading
+        */
+       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
+                                SPI_NFI_DMA_MODE |
+                                SPI_NFI_READ_MODE |
+                                SPI_NFI_DMA_BURST_EN |
+                                SPI_NFI_HW_ECC_EN |
+                                SPI_NFI_AUTO_FDM_EN |
+                                SPI_NFI_OPMODE,
+                                SPI_NFI_DMA_MODE |
+                                SPI_NFI_READ_MODE |
+                                SPI_NFI_DMA_BURST_EN |
+                                FIELD_PREP(SPI_NFI_OPMODE, 6));
+       if (err)
+               goto error_dma_mode_off;
+
+       /* Set number of sector will be read */
+       val = FIELD_PREP(SPI_NFI_SEC_NUM, priv->nfi_cfg.sec_num);
+       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CON,
+                                SPI_NFI_SEC_NUM, val);
+       if (err)
+               goto error_dma_mode_off;
+
+       /* Set custom sector size */
+       val = priv->nfi_cfg.sec_size;
+       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_SECCUS_SIZE,
+                                SPI_NFI_CUS_SEC_SIZE |
+                                SPI_NFI_CUS_SEC_SIZE_EN,
+                                FIELD_PREP(SPI_NFI_CUS_SEC_SIZE, val) |
+                                SPI_NFI_CUS_SEC_SIZE_EN);
        if (err)
                goto error_dma_mode_off;
 
@@ -658,7 +699,14 @@ static ssize_t airoha_snand_dirmap_read(struct spi_mem_dirmap_desc *desc,
        if (err)
                goto error_dma_unmap;
 
-       /* set cust sec size */
+       /*
+        * Setup transfer length
+        * ---------------------
+        * The following rule MUST be met:
+        *     transfer_length =
+        *        = NFI_SNF_MISC_CTL2.read_data_byte_number =
+        *        = NFI_CON.sector_number * NFI_SECCUS.custom_sector_size
+        */
        val = priv->nfi_cfg.sec_size * priv->nfi_cfg.sec_num;
        val = FIELD_PREP(SPI_NFI_READ_DATA_BYTE_NUM, val);
        err = regmap_update_bits(priv->regmap_nfi,
@@ -685,18 +733,6 @@ static ssize_t airoha_snand_dirmap_read(struct spi_mem_dirmap_desc *desc,
        if (err)
                goto error_dma_unmap;
 
-       /* set nfi read */
-       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-                                SPI_NFI_OPMODE,
-                                FIELD_PREP(SPI_NFI_OPMODE, 6));
-       if (err)
-               goto error_dma_unmap;
-
-       err = regmap_set_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-                             SPI_NFI_READ_MODE | SPI_NFI_DMA_MODE);
-       if (err)
-               goto error_dma_unmap;
-
        err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CMD, 0x0);
        if (err)
                goto error_dma_unmap;
@@ -791,7 +827,48 @@ static ssize_t airoha_snand_dirmap_write(struct spi_mem_dirmap_desc *desc,
        if (err < 0)
                return err;
 
-       err = airoha_snand_nfi_config(priv);
+       /* NFI reset */
+       err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CON,
+                          SPI_NFI_FIFO_FLUSH | SPI_NFI_RST);
+       if (err)
+               goto error_dma_mode_off;
+
+       /*
+        * NFI configure:
+        *   - No AutoFDM (custom sector size (SECCUS) register will be used)
+        *   - No SoC's hardware ECC (flash internal ECC will be used)
+        *   - Use burst mode (faster, but requires 16 byte alignment for addresses)
+        *   - Setup for writing (SPI_NFI_READ_MODE bit is cleared)
+        *   - Setup writing command: FIELD_PREP(SPI_NFI_OPMODE, 3)
+        *   - Use DMA instead of PIO for data writing
+        */
+       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
+                                SPI_NFI_DMA_MODE |
+                                SPI_NFI_READ_MODE |
+                                SPI_NFI_DMA_BURST_EN |
+                                SPI_NFI_HW_ECC_EN |
+                                SPI_NFI_AUTO_FDM_EN |
+                                SPI_NFI_OPMODE,
+                                SPI_NFI_DMA_MODE |
+                                SPI_NFI_DMA_BURST_EN |
+                                FIELD_PREP(SPI_NFI_OPMODE, 3));
+       if (err)
+               goto error_dma_mode_off;
+
+       /* Set number of sector will be written */
+       val = FIELD_PREP(SPI_NFI_SEC_NUM, priv->nfi_cfg.sec_num);
+       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CON,
+                                SPI_NFI_SEC_NUM, val);
+       if (err)
+               goto error_dma_mode_off;
+
+       /* Set custom sector size */
+       val = priv->nfi_cfg.sec_size;
+       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_SECCUS_SIZE,
+                                SPI_NFI_CUS_SEC_SIZE |
+                                SPI_NFI_CUS_SEC_SIZE_EN,
+                                FIELD_PREP(SPI_NFI_CUS_SEC_SIZE, val) |
+                                SPI_NFI_CUS_SEC_SIZE_EN);
        if (err)
                goto error_dma_mode_off;
 
@@ -804,8 +881,16 @@ static ssize_t airoha_snand_dirmap_write(struct spi_mem_dirmap_desc *desc,
        if (err)
                goto error_dma_unmap;
 
-       val = FIELD_PREP(SPI_NFI_PROG_LOAD_BYTE_NUM,
-                        priv->nfi_cfg.sec_size * priv->nfi_cfg.sec_num);
+       /*
+        * Setup transfer length
+        * ---------------------
+        * The following rule MUST be met:
+        *     transfer_length =
+        *        = NFI_SNF_MISC_CTL2.write_data_byte_number =
+        *        = NFI_CON.sector_number * NFI_SECCUS.custom_sector_size
+        */
+       val = priv->nfi_cfg.sec_size * priv->nfi_cfg.sec_num;
+       val = FIELD_PREP(SPI_NFI_PROG_LOAD_BYTE_NUM, val);
        err = regmap_update_bits(priv->regmap_nfi,
                                 REG_SPI_NFI_SNF_MISC_CTL2,
                                 SPI_NFI_PROG_LOAD_BYTE_NUM, val);
@@ -830,22 +915,6 @@ static ssize_t airoha_snand_dirmap_write(struct spi_mem_dirmap_desc *desc,
        if (err)
                goto error_dma_unmap;
 
-       err = regmap_clear_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-                               SPI_NFI_READ_MODE);
-       if (err)
-               goto error_dma_unmap;
-
-       err = regmap_update_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-                                SPI_NFI_OPMODE,
-                                FIELD_PREP(SPI_NFI_OPMODE, 3));
-       if (err)
-               goto error_dma_unmap;
-
-       err = regmap_set_bits(priv->regmap_nfi, REG_SPI_NFI_CNFG,
-                             SPI_NFI_DMA_MODE);
-       if (err)
-               goto error_dma_unmap;
-
        err = regmap_write(priv->regmap_nfi, REG_SPI_NFI_CMD, 0x80);
        if (err)
                goto error_dma_unmap;