serial: imx: set receiver level before starting uart

Set the receiver level to something > 0 before calling imx_uart_start_rx
in rs485_config. This is necessary to avoid an interrupt storm that
might prevent the system from booting. This was seen on an i.MX7 device
when the rs485-rts-active-low property was active in the device tree.

Fixes: 6d215f83e5fc ("serial: imx: warn user when using unsupported configuration")
Cc: stable <stable@kernel.org>
Signed-off-by: Stefan Eichenberger <stefan.eichenberger@toradex.com>
Link: https://lore.kernel.org/r/20240621153829.183780-1-eichest@gmail.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index 2eb22594960f35df94897d54a743a36fdd3034b5..f4f40c9373c2f75136e7987cdb168611ecbe980c 100644 (file)
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -1952,8 +1952,10 @@ static int imx_uart_rs485_config(struct uart_port *port, struct ktermios *termio
 
        /* Make sure Rx is enabled in case Tx is active with Rx disabled */
        if (!(rs485conf->flags & SER_RS485_ENABLED) ||
-           rs485conf->flags & SER_RS485_RX_DURING_TX)
+           rs485conf->flags & SER_RS485_RX_DURING_TX) {
+               imx_uart_setup_ufcr(sport, TXTL_DEFAULT, RXTL_DEFAULT);
                imx_uart_start_rx(port);
+       }
 
        return 0;
 }