/*
* PCIe controller driver for Renesas R-Car Gen4 Series SoCs
* Copyright (C) 2022-2023 Renesas Electronics Corporation
+ *
+ * The r8a779g0 (R-Car V4H) controller requires a specific firmware to be
+ * provided, to initialize the PHY. Otherwise, the PCIe controller will not
+ * work.
*/
#include <linux/delay.h>
+#include <linux/firmware.h>
#include <linux/interrupt.h>
#include <linux/io.h>
+#include <linux/iopoll.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/pci.h>
/* Renesas-specific */
/* PCIe Mode Setting Register 0 */
#define PCIEMSR0 0x0000
-#define BIFUR_MOD_SET_ON BIT(0)
+#define APP_SRIS_MODE BIT(6)
#define DEVICE_TYPE_EP 0
#define DEVICE_TYPE_RC BIT(4)
+#define BIFUR_MOD_SET_ON BIT(0)
/* PCIe Interrupt Status 0 */
#define PCIEINTSTS0 0x0084
#define PCIEDMAINTSTSEN 0x0314
#define PCIEDMAINTSTSEN_INIT GENMASK(15, 0)
+/* Port Logic Registers 89 */
+#define PRTLGC89 0x0b70
+
+/* Port Logic Registers 90 */
+#define PRTLGC90 0x0b74
+
/* PCIe Reset Control Register 1 */
#define PCIERSTCTRL1 0x0014
#define APP_HOLD_PHY_RST BIT(16)
#define APP_LTSSM_ENABLE BIT(0)
+/* PCIe Power Management Control */
+#define PCIEPWRMNGCTRL 0x0070
+#define APP_CLK_REQ_N BIT(11)
+#define APP_CLK_PM_EN BIT(10)
+
#define RCAR_NUM_SPEED_CHANGE_RETRIES 10
#define RCAR_MAX_LINK_SPEED 4
#define RCAR_GEN4_PCIE_EP_FUNC_DBI_OFFSET 0x1000
#define RCAR_GEN4_PCIE_EP_FUNC_DBI2_OFFSET 0x800
+#define RCAR_GEN4_PCIE_FIRMWARE_NAME "rcar_gen4_pcie.bin"
+#define RCAR_GEN4_PCIE_FIRMWARE_BASE_ADDR 0xc000
+MODULE_FIRMWARE(RCAR_GEN4_PCIE_FIRMWARE_NAME);
+
struct rcar_gen4_pcie;
struct rcar_gen4_pcie_drvdata {
+ void (*additional_common_init)(struct rcar_gen4_pcie *rcar);
int (*ltssm_control)(struct rcar_gen4_pcie *rcar, bool enable);
enum dw_pcie_device_mode mode;
};
struct rcar_gen4_pcie {
struct dw_pcie dw;
void __iomem *base;
+ void __iomem *phy_base;
struct platform_device *pdev;
const struct rcar_gen4_pcie_drvdata *drvdata;
};
if (ret)
goto err_unprepare;
+ if (rcar->drvdata->additional_common_init)
+ rcar->drvdata->additional_common_init(rcar);
+
return 0;
err_unprepare:
static int rcar_gen4_pcie_get_resources(struct rcar_gen4_pcie *rcar)
{
+ rcar->phy_base = devm_platform_ioremap_resource_byname(rcar->pdev, "phy");
+ if (IS_ERR(rcar->phy_base))
+ return PTR_ERR(rcar->phy_base);
+
/* Renesas-specific registers */
rcar->base = devm_platform_ioremap_resource_byname(rcar->pdev, "app");
return 0;
}
+static void rcar_gen4_pcie_additional_common_init(struct rcar_gen4_pcie *rcar)
+{
+ struct dw_pcie *dw = &rcar->dw;
+ u32 val;
+
+ val = dw_pcie_readl_dbi(dw, PCIE_PORT_LANE_SKEW);
+ val &= ~PORT_LANE_SKEW_INSERT_MASK;
+ if (dw->num_lanes < 4)
+ val |= BIT(6);
+ dw_pcie_writel_dbi(dw, PCIE_PORT_LANE_SKEW, val);
+
+ val = readl(rcar->base + PCIEPWRMNGCTRL);
+ val |= APP_CLK_REQ_N | APP_CLK_PM_EN;
+ writel(val, rcar->base + PCIEPWRMNGCTRL);
+}
+
+static void rcar_gen4_pcie_phy_reg_update_bits(struct rcar_gen4_pcie *rcar,
+ u32 offset, u32 mask, u32 val)
+{
+ u32 tmp;
+
+ tmp = readl(rcar->phy_base + offset);
+ tmp &= ~mask;
+ tmp |= val;
+ writel(tmp, rcar->phy_base + offset);
+}
+
+/*
+ * SoC datasheet suggests checking port logic register bits during firmware
+ * write. If read returns non-zero value, then this function returns -EAGAIN
+ * indicating that the write needs to be done again. If read returns zero,
+ * then return 0 to indicate success.
+ */
+static int rcar_gen4_pcie_reg_test_bit(struct rcar_gen4_pcie *rcar,
+ u32 offset, u32 mask)
+{
+ struct dw_pcie *dw = &rcar->dw;
+
+ if (dw_pcie_readl_dbi(dw, offset) & mask)
+ return -EAGAIN;
+
+ return 0;
+}
+
+static int rcar_gen4_pcie_download_phy_firmware(struct rcar_gen4_pcie *rcar)
+{
+ /* The check_addr values are magical numbers in the datasheet */
+ const u32 check_addr[] = { 0x00101018, 0x00101118, 0x00101021, 0x00101121};
+ struct dw_pcie *dw = &rcar->dw;
+ const struct firmware *fw;
+ unsigned int i, timeout;
+ u32 data;
+ int ret;
+
+ ret = request_firmware(&fw, RCAR_GEN4_PCIE_FIRMWARE_NAME, dw->dev);
+ if (ret) {
+ dev_err(dw->dev, "Failed to load firmware (%s): %d\n",
+ RCAR_GEN4_PCIE_FIRMWARE_NAME, ret);
+ return ret;
+ }
+
+ for (i = 0; i < (fw->size / 2); i++) {
+ data = fw->data[(i * 2) + 1] << 8 | fw->data[i * 2];
+ timeout = 100;
+ do {
+ dw_pcie_writel_dbi(dw, PRTLGC89, RCAR_GEN4_PCIE_FIRMWARE_BASE_ADDR + i);
+ dw_pcie_writel_dbi(dw, PRTLGC90, data);
+ if (!rcar_gen4_pcie_reg_test_bit(rcar, PRTLGC89, BIT(30)))
+ break;
+ if (!(--timeout)) {
+ ret = -ETIMEDOUT;
+ goto exit;
+ }
+ usleep_range(100, 200);
+ } while (1);
+ }
+
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x0f8, BIT(17), BIT(17));
+
+ for (i = 0; i < ARRAY_SIZE(check_addr); i++) {
+ timeout = 100;
+ do {
+ dw_pcie_writel_dbi(dw, PRTLGC89, check_addr[i]);
+ ret = rcar_gen4_pcie_reg_test_bit(rcar, PRTLGC89, BIT(30));
+ ret |= rcar_gen4_pcie_reg_test_bit(rcar, PRTLGC90, BIT(0));
+ if (!ret)
+ break;
+ if (!(--timeout)) {
+ ret = -ETIMEDOUT;
+ goto exit;
+ }
+ usleep_range(100, 200);
+ } while (1);
+ }
+
+exit:
+ release_firmware(fw);
+
+ return ret;
+}
+
+static int rcar_gen4_pcie_ltssm_control(struct rcar_gen4_pcie *rcar, bool enable)
+{
+ struct dw_pcie *dw = &rcar->dw;
+ u32 val;
+ int ret;
+
+ if (!enable) {
+ val = readl(rcar->base + PCIERSTCTRL1);
+ val &= ~APP_LTSSM_ENABLE;
+ writel(val, rcar->base + PCIERSTCTRL1);
+
+ return 0;
+ }
+
+ val = dw_pcie_readl_dbi(dw, PCIE_PORT_FORCE);
+ val |= PORT_FORCE_DO_DESKEW_FOR_SRIS;
+ dw_pcie_writel_dbi(dw, PCIE_PORT_FORCE, val);
+
+ val = readl(rcar->base + PCIEMSR0);
+ val |= APP_SRIS_MODE;
+ writel(val, rcar->base + PCIEMSR0);
+
+ /*
+ * The R-Car Gen4 datasheet doesn't describe the PHY registers' name.
+ * But, the initialization procedure describes these offsets. So,
+ * this driver has magical offset numbers.
+ */
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x700, BIT(28), 0);
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x700, BIT(20), 0);
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x700, BIT(12), 0);
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x700, BIT(4), 0);
+
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x148, GENMASK(23, 22), BIT(22));
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x148, GENMASK(18, 16), GENMASK(17, 16));
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x148, GENMASK(7, 6), BIT(6));
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x148, GENMASK(2, 0), GENMASK(11, 0));
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x1d4, GENMASK(16, 15), GENMASK(16, 15));
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x514, BIT(26), BIT(26));
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x0f8, BIT(16), 0);
+ rcar_gen4_pcie_phy_reg_update_bits(rcar, 0x0f8, BIT(19), BIT(19));
+
+ val = readl(rcar->base + PCIERSTCTRL1);
+ val &= ~APP_HOLD_PHY_RST;
+ writel(val, rcar->base + PCIERSTCTRL1);
+
+ ret = readl_poll_timeout(rcar->phy_base + 0x0f8, val, !(val & BIT(18)), 100, 10000);
+ if (ret < 0)
+ return ret;
+
+ ret = rcar_gen4_pcie_download_phy_firmware(rcar);
+ if (ret)
+ return ret;
+
+ val = readl(rcar->base + PCIERSTCTRL1);
+ val |= APP_LTSSM_ENABLE;
+ writel(val, rcar->base + PCIERSTCTRL1);
+
+ return 0;
+}
+
static struct rcar_gen4_pcie_drvdata drvdata_r8a779f0_pcie = {
.ltssm_control = r8a779f0_pcie_ltssm_control,
.mode = DW_PCIE_RC_TYPE,
};
static struct rcar_gen4_pcie_drvdata drvdata_rcar_gen4_pcie = {
+ .additional_common_init = rcar_gen4_pcie_additional_common_init,
+ .ltssm_control = rcar_gen4_pcie_ltssm_control,
.mode = DW_PCIE_RC_TYPE,
};
static struct rcar_gen4_pcie_drvdata drvdata_rcar_gen4_pcie_ep = {
+ .additional_common_init = rcar_gen4_pcie_additional_common_init,
+ .ltssm_control = rcar_gen4_pcie_ltssm_control,
.mode = DW_PCIE_EP_TYPE,
};
projects / thirdparty / kernel / linux.git / commitdiff
