From: Manuel Fombuena Date: Wed, 26 Feb 2025 17:08:44 +0000 (+0000) Subject: leds: leds-st1202: Spacing and proofreading editing X-Git-Tag: v6.15-rc1~108^2~7 X-Git-Url: http://git.ipfire.org/?a=commitdiff_plain;h=5d0e4816a9e7ee663e3f32e96b45d79aa900c398;p=thirdparty%2Flinux.git leds: leds-st1202: Spacing and proofreading editing Minor edits regarding use of spacing and proofreading. There is a minor inconsistency in the use of spacing as margin in one of the comments providing details about the datasheet. There is also a typo that comes from the datasheet itself. Change spacing on comment and correct typo. Signed-off-by: Manuel Fombuena Link: https://lore.kernel.org/r/CWLP123MB547333EFFFBFFA840225BC02C5C22@CWLP123MB5473.GBRP123.PROD.OUTLOOK.COM Signed-off-by: Lee Jones --- diff --git a/drivers/leds/leds-st1202.c b/drivers/leds/leds-st1202.c index 3ddf2786a7452..eb75c2d36d47d 100644 --- a/drivers/leds/leds-st1202.c +++ b/drivers/leds/leds-st1202.c @@ -99,9 +99,9 @@ static int st1202_pwm_pattern_write(struct st1202_chip *chip, int led_num, value_h = (u8)(value >> 8); /* - * Datasheet: Register address low = 1Eh + 2*(xh) + 18h*(yh), - * where x is the channel number (led number) in hexadecimal (x = 00h .. 0Bh) - * and y is the pattern number in hexadecimal (y = 00h .. 07h) + * Datasheet: Register address low = 1Eh + 2*(xh) + 18h*(yh), + * where x is the channel number (led number) in hexadecimal (x = 00h .. 0Bh) + * and y is the pattern number in hexadecimal (y = 00h .. 07h) */ ret = st1202_write_reg(chip, (ST1202_PATTERN_PWM + (led_num * 2) + 0x18 * pattern), value_l); @@ -298,8 +298,8 @@ static int st1202_setup(struct st1202_chip *chip) guard(mutex)(&chip->lock); /* - * Once the supply voltage is applied, the LED1202 executes some internal checks, - * afterwords it stops the oscillator and puts the internal LDO in quiescent mode. + * Once the supply voltage is applied, the LED1202 executes some internal checks. + * Afterwards, it stops the oscillator and puts the internal LDO in quiescent mode. * To start the device, EN bit must be set inside the “Device Enable” register at * address 01h. As soon as EN is set, the LED1202 loads the adjustment parameters * from the internal non-volatile memory and performs an auto-calibration procedure