From: Michal Simek <michal.simek@xilinx.com>
Date: Tue, 26 Oct 2021 05:20:52 +0000 (+0200)
Subject: arm64: zynqmp: Move usb hub from i2c to usb node
X-Git-Url: http://git.ipfire.org/?a=commitdiff_plain;h=8a413a272df0f35f9060574d5b76a5e5bb799a70;p=thirdparty%2Fu-boot.git

arm64: zynqmp: Move usb hub from i2c to usb node

Based on upstream discussion based on link below usb hub should be placed
to usb node directly as child node. Based on this Linux driver was updated
and the same change should be also reflected in kv260 board.

Link: https://lore.kernel.org/all/CAL_JsqJZBbu+UXqUNdZwg-uv0PAsNg55026PTwhKr5wQtxCjVQ@mail.gmail.com/
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
---

diff --git a/arch/arm/dts/zynqmp-sck-kv-g-revB.dts b/arch/arm/dts/zynqmp-sck-kv-g-revB.dts
index 8f7c8889f90..7edc6ce91d0 100644
--- a/arch/arm/dts/zynqmp-sck-kv-g-revB.dts
+++ b/arch/arm/dts/zynqmp-sck-kv-g-revB.dts
@@ -36,11 +36,7 @@
 		label = "ina260-u14";
 		reg = <0x40>;
 	};
-	usbhub: usb5744@2d { /* u43 */
-		compatible = "microchip,usb5744";
-		reg = <0x2d>;
-		reset-gpios = <&gpio 44 GPIO_ACTIVE_HIGH>;
-	};
+	/* u43 - 0x2d - USB hub */
 	/* u27 - 0xe0 - STDP4320 DP/HDMI splitter */
 };
 
@@ -111,6 +107,13 @@
 	pinctrl-0 = <&pinctrl_usb0_default>;
 	phy-names = "usb3-phy";
 	phys = <&psgtr 2 PHY_TYPE_USB3 0 1>;
+
+	usbhub: usb5744@2d { /* u43 */
+		status = "okay";
+		compatible = "microchip,usb5744";
+		i2c-bus = <&i2c1>;
+		reset-gpios = <&gpio 44 GPIO_ACTIVE_HIGH>;
+	};
 };
 
 &dwc3_0 {