From: Tristram Ha Date: Wed, 19 Jun 2024 00:16:42 +0000 (-0700) Subject: net: dsa: microchip: fix initial port flush problem X-Git-Tag: v6.10-rc6~35^2~30 X-Git-Url: http://git.ipfire.org/?a=commitdiff_plain;h=ad53f5f54f351e967128edbc431f0f26427172cf;p=thirdparty%2Fkernel%2Flinux.git net: dsa: microchip: fix initial port flush problem The very first flush in any port will flush all learned addresses in all ports. This can be observed by unplugging the cable from one port while additional ports are connected and dumping the fdb entries. This problem is caused by the initially wrong value programmed to the REG_SW_LUE_CTRL_1 register. Setting SW_FLUSH_STP_TABLE and SW_FLUSH_MSTP_TABLE bits does not have an immediate effect. It is when ksz9477_flush_dyn_mac_table() is called then the SW_FLUSH_STP_TABLE bit takes effect and flushes all learned entries. After that call both bits are reset and so the next port flush will not cause such problem again. Fixes: b987e98e50ab ("dsa: add DSA switch driver for Microchip KSZ9477") Signed-off-by: Tristram Ha Link: https://patch.msgid.link/1718756202-2731-1-git-send-email-Tristram.Ha@microchip.com Signed-off-by: Jakub Kicinski --- diff --git a/drivers/net/dsa/microchip/ksz9477.c b/drivers/net/dsa/microchip/ksz9477.c index f8ad7833f5d9d..2231128eef8b8 100644 --- a/drivers/net/dsa/microchip/ksz9477.c +++ b/drivers/net/dsa/microchip/ksz9477.c @@ -355,10 +355,8 @@ int ksz9477_reset_switch(struct ksz_device *dev) SPI_AUTO_EDGE_DETECTION, 0); /* default configuration */ - ksz_read8(dev, REG_SW_LUE_CTRL_1, &data8); - data8 = SW_AGING_ENABLE | SW_LINK_AUTO_AGING | - SW_SRC_ADDR_FILTER | SW_FLUSH_STP_TABLE | SW_FLUSH_MSTP_TABLE; - ksz_write8(dev, REG_SW_LUE_CTRL_1, data8); + ksz_write8(dev, REG_SW_LUE_CTRL_1, + SW_AGING_ENABLE | SW_LINK_AUTO_AGING | SW_SRC_ADDR_FILTER); /* disable interrupts */ ksz_write32(dev, REG_SW_INT_MASK__4, SWITCH_INT_MASK);