From: Linus Torvalds <torvalds@linux-foundation.org>
Date: Thu, 31 Jul 2025 20:43:02 +0000 (-0700)
Subject: Merge tag 'mtd/for-6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux
X-Git-Url: http://git.ipfire.org/?a=commitdiff_plain;h=cbbf0a759ff96c80dfc32192a2cc427b79447f74;p=thirdparty%2Fkernel%2Flinux.git

Merge tag 'mtd/for-6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux

Pull mtd updates from Miquel Raynal:
 "MTD changes:

   - Apart from a binding conversion to yaml, only minor changes/small
     fixes have been merged.

  Raw NAND changes:

   - Minor fixes for various controller drivers like DMA mapping checks,
     better timing derivations or bitflip statistics.

   - some Hynix NAND flashes were not supporting read-retries, so don't
     even try to do it

  SPI NAND changes:

   - In order to support high-speed modes, certain chips need extra
     configuration like adding more dummy cycles. This is now possible,
     especially on Winbond chips.

   - Aside from that, Gigadevice gets support for a new chip (GD5F1GM9).

  SPI NOR changes:

   - A notable changes is the fix for exiting 4-byte addressing on
     Infineon SEMPER flashes. These flashes do not support the standard
     EX4B opcode (E9h), and use a vendor-specific opcode (B8h) instead.

   - There is also a fix for unlocking flashes that are write-protected
     at power-on. This was caused by using an uninitialized mtd_info in
     spi_nor_try_unlock_all()"

* tag 'mtd/for-6.17' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux: (26 commits)
  mtd: spinand: winbond: Add comment about the maximum frequency
  mtd: spinand: winbond: Enable high-speed modes on w35n0xjw
  mtd: spinand: winbond: Enable high-speed modes on w25n0xjw
  mtd: spinand: Add a ->configure_chip() hook
  mtd: spinand: Add a frequency field to all READ_FROM_CACHE variants
  mtd: spinand: Fix macro alignment
  spi: spi-mem: Take into account the actual maximum frequency
  spi: spi-mem: Use picoseconds for calculating the op durations
  mtd: rawnand: atmel: set pmecc data setup time
  mtd: spinand: propagate spinand_wait() errors from spinand_write_page()
  mtd: rawnand: fsmc: Add missing check after DMA map
  mtd: rawnand: rockchip: Add missing check after DMA map
  mtd: rawnand: hynix: don't try read-retry on SLC NANDs
  mtd: rawnand: atmel: Fix dma_mapping_error() address
  mtd: nand: brcmnand: fix mtd corrected bits stat
  mtd: rawnand: renesas: Add missing check after DMA map
  mtd: spinand: gigadevice: Add support for GD5F1GM9 chips
  mtd: nand: brcmnand: replace manual string choices with standard helpers
  mtd: map: Don't use "proxy" headers
  mtd: spi-nor: Fix spi_nor_try_unlock_all()
  ...
---

cbbf0a759ff96c80dfc32192a2cc427b79447f74