From: David Collins Date: Sat, 12 May 2018 01:46:46 +0000 (-0700) Subject: regulator: of: add property for allowed modes specification X-Git-Tag: v4.18-rc1~86^2~38 X-Git-Url: http://git.ipfire.org/?a=commitdiff_plain;h=d73e2842a3e236a1f58ba498e4d6ae58e18f660a;p=thirdparty%2Fkernel%2Flinux.git regulator: of: add property for allowed modes specification Add a common device tree property for regulator nodes to support the specification of allowed operating modes. Signed-off-by: David Collins Signed-off-by: Mark Brown --- diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt index 2babe15b618d9..c627aa08f0da8 100644 --- a/Documentation/devicetree/bindings/regulator/regulator.txt +++ b/Documentation/devicetree/bindings/regulator/regulator.txt @@ -59,6 +59,11 @@ Optional properties: - regulator-initial-mode: initial operating mode. The set of possible operating modes depends on the capabilities of every hardware so each device binding documentation explains which values the regulator supports. +- regulator-allowed-modes: list of operating modes that software is allowed to + configure for the regulator at run-time. Elements may be specified in any + order. The set of possible operating modes depends on the capabilities of + every hardware so each device binding document explains which values the + regulator supports. - regulator-system-load: Load in uA present on regulator that is not captured by any consumer request. - regulator-pull-down: Enable pull down resistor when the regulator is disabled.