From: Martin Blumenstingl Date: Sat, 29 Mar 2025 19:01:32 +0000 (+0100) Subject: pinctrl: meson: define the pull up/down resistor value as 60 kOhm X-Git-Tag: v6.15-rc5~19^2~5 X-Git-Url: http://git.ipfire.org/?a=commitdiff_plain;h=e56088a13708757da68ad035269d69b93ac8c389;p=thirdparty%2Fkernel%2Flinux.git pinctrl: meson: define the pull up/down resistor value as 60 kOhm The public datasheets of the following Amlogic SoCs describe a typical resistor value for the built-in pull up/down resistor: - Meson8/8b/8m2: not documented - GXBB (S905): 60 kOhm - GXL (S905X): 60 kOhm - GXM (S912): 60 kOhm - G12B (S922X): 60 kOhm - SM1 (S905D3): 60 kOhm The public G12B and SM1 datasheets additionally state min and max values: - min value: 50 kOhm for both, pull-up and pull-down - max value for the pull-up: 70 kOhm - max value for the pull-down: 130 kOhm Use 60 kOhm in the pinctrl-meson driver as well so it's shown in the debugfs output. It may not be accurate for Meson8/8b/8m2 but in reality 60 kOhm is closer to the actual value than 1 Ohm. Signed-off-by: Martin Blumenstingl Reviewed-by: Neil Armstrong Link: https://lore.kernel.org/20250329190132.855196-1-martin.blumenstingl@googlemail.com Signed-off-by: Linus Walleij --- diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c index 253a0cc57e396..e5a32a0532eee 100644 --- a/drivers/pinctrl/meson/pinctrl-meson.c +++ b/drivers/pinctrl/meson/pinctrl-meson.c @@ -487,7 +487,7 @@ static int meson_pinconf_get(struct pinctrl_dev *pcdev, unsigned int pin, case PIN_CONFIG_BIAS_PULL_DOWN: case PIN_CONFIG_BIAS_PULL_UP: if (meson_pinconf_get_pull(pc, pin) == param) - arg = 1; + arg = 60000; else return -EINVAL; break;