From fa70bb0c8504a29fe0dd80991b3d1213010a2dde Mon Sep 17 00:00:00 2001 From: Damien Le Moal Date: Wed, 18 Jun 2025 16:25:19 +0900 Subject: [PATCH] ata: Fix SATA_MOBILE_LPM_POLICY description in Kconfig commit ed62a62a18bc144f73eadf866ae46842e8f6606e upstream. Improve the description of the possible default SATA link power management policies and add the missing description for policy 5. No functional changes. Fixes: a5ec5a7bfd1f ("ata: ahci: Support state with min power but Partial low power state") Cc: stable@vger.kernel.org Signed-off-by: Damien Le Moal Reviewed-by: Hannes Reinecke Reviewed-by: Niklas Cassel Signed-off-by: Greg Kroah-Hartman --- drivers/ata/Kconfig | 36 ++++++++++++++++++++++++++---------- 1 file changed, 26 insertions(+), 10 deletions(-) diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig index e00536b495529..120a2b7067fc7 100644 --- a/drivers/ata/Kconfig +++ b/drivers/ata/Kconfig @@ -117,23 +117,39 @@ config SATA_AHCI config SATA_MOBILE_LPM_POLICY int "Default SATA Link Power Management policy" - range 0 4 + range 0 5 default 3 depends on SATA_AHCI help Select the Default SATA Link Power Management (LPM) policy to use for chipsets / "South Bridges" supporting low-power modes. Such chipsets are ubiquitous across laptops, desktops and servers. - - The value set has the following meanings: + Each policy combines power saving states and features: + - Partial: The Phy logic is powered but is in a reduced power + state. The exit latency from this state is no longer than + 10us). + - Slumber: The Phy logic is powered but is in an even lower power + state. The exit latency from this state is potentially + longer, but no longer than 10ms. + - DevSleep: The Phy logic may be powered down. The exit latency from + this state is no longer than 20 ms, unless otherwise + specified by DETO in the device Identify Device Data log. + - HIPM: Host Initiated Power Management (host automatically + transitions to partial and slumber). + - DIPM: Device Initiated Power Management (device automatically + transitions to partial and slumber). + + The possible values for the default SATA link power management + policies are: 0 => Keep firmware settings - 1 => Maximum performance - 2 => Medium power - 3 => Medium power with Device Initiated PM enabled - 4 => Minimum power - - Note "Minimum power" is known to cause issues, including disk - corruption, with some disks and should not be used. + 1 => No power savings (maximum performance) + 2 => HIPM (Partial) + 3 => HIPM (Partial) and DIPM (Partial and Slumber) + 4 => HIPM (Partial and DevSleep) and DIPM (Partial and Slumber) + 5 => HIPM (Slumber and DevSleep) and DIPM (Partial and Slumber) + + Excluding the value 0, higher values represent policies with higher + power savings. config SATA_AHCI_PLATFORM tristate "Platform AHCI SATA support" -- 2.47.3