[people/ms/u-boot.git] / include / configs / socfpga_mcvevk.h

/*
 * Copyright (C) 2015 Marek Vasut <marex@denx.de>
 *
 * SPDX-License-Identifier:	GPL-2.0+
 */
#ifndef __CONFIG_DENX_MCVEVK_H__
#define __CONFIG_DENX_MCVEVK_H__

#include <asm/arch/socfpga_base_addrs.h>

/* U-Boot Commands */
#define CONFIG_SYS_NO_FLASH
#define CONFIG_DOS_PARTITION
#define CONFIG_FAT_WRITE
#define CONFIG_HW_WATCHDOG

#define CONFIG_CMD_ASKENV
#define CONFIG_CMD_BOOTZ
#define CONFIG_CMD_CACHE
#define CONFIG_CMD_DFU
#define CONFIG_CMD_DHCP
#define CONFIG_CMD_EXT4
#define CONFIG_CMD_EXT4_WRITE
#define CONFIG_CMD_FAT
#define CONFIG_CMD_FS_GENERIC
#define CONFIG_CMD_GPIO
#define CONFIG_CMD_GREPENV
#define CONFIG_CMD_MII
#define CONFIG_CMD_MMC
#define CONFIG_CMD_PING
#define CONFIG_CMD_USB
#define CONFIG_CMD_USB_MASS_STORAGE

/* Memory configurations */
#define PHYS_SDRAM_1_SIZE		0x40000000	/* 1GiB on MCV */

/* Booting Linux */
#define CONFIG_BOOTDELAY	3
#define CONFIG_BOOTFILE		"fitImage"
#define CONFIG_BOOTARGS		"console=ttyS0," __stringify(CONFIG_BAUDRATE)
#define CONFIG_PREBOOT		"run try_bootscript"
#define CONFIG_BOOTCOMMAND	"run mmc_mmc"
#define CONFIG_LOADADDR		0x01000000
#define CONFIG_SYS_LOAD_ADDR	CONFIG_LOADADDR

#define CONFIG_ENV_IS_NOWHERE

/* USB */
#ifdef CONFIG_CMD_USB
#define CONFIG_USB_DWC2_REG_ADDR	SOCFPGA_USB1_ADDRESS
#endif
#define CONFIG_G_DNL_MANUFACTURER	"DENX"

/* Extra Environment */
#define CONFIG_HOSTNAME			mcvevk

#define CONFIG_EXTRA_ENV_SETTINGS					\
	"consdev=ttyS0\0"						\
	"baudrate=115200\0"						\
	"bootscript=boot.scr\0"						\
	"bootdev=/dev/mmcblk0p2\0"					\
	"rootdev=/dev/mmcblk0p3\0"					\
	"netdev=eth0\0"							\
	"hostname=mcvevk\0"						\
	"kernel_addr_r=0x10000000\0"					\
	"update_filename=u-boot-with-spl-dtb.sfp\0"			\
	"update_sd_offset=0x800\0"					\
	"update_sd="		/* Update the SD firmware partition */	\
		"if mmc rescan ; then "					\
		"if tftp ${update_filename} ; then "			\
		"setexpr fw_sz ${filesize} / 0x200 ; "	/* SD block size */ \
		"setexpr fw_sz ${fw_sz} + 1 ; "				\
		"mmc write ${loadaddr} ${update_sd_offset} ${fw_sz} ; "	\
		"fi ; "							\
		"fi\0"							\
	"update_qspi_offset=0x0\0"					\
	"update_qspi="		/* Update the QSPI firmware */		\
		"if sf probe ; then "					\
		"if tftp ${update_filename} ; then "			\
		"sf update ${loadaddr} ${update_qspi_offset} ${filesize} ; " \
		"fi ; "							\
		"fi\0"							\
	"fpga_filename=output_file.rbf\0"				\
	"load_fpga="		/* Load FPGA bitstream */		\
		"if tftp ${fpga_filename} ; then "			\
		"fpga load 0 $loadaddr $filesize ; "			\
		"bridge enable ; "					\
		"fi\0"							\
	"addcons="							\
		"setenv bootargs ${bootargs} "				\
		"console=${consdev},${baudrate}\0"			\
	"addip="							\
		"setenv bootargs ${bootargs} "				\
		"ip=${ipaddr}:${serverip}:${gatewayip}:"		\
			"${netmask}:${hostname}:${netdev}:off\0"	\
	"addmisc="							\
		"setenv bootargs ${bootargs} ${miscargs}\0"		\
	"addargs=run addcons addmisc\0"					\
	"mmcload="							\
		"mmc rescan ; "						\
		"load mmc 0:2 ${kernel_addr_r} ${bootfile}\0"		\
	"netload="							\
		"tftp ${kernel_addr_r} ${hostname}/${bootfile}\0"	\
	"miscargs=nohlt panic=1\0"					\
	"mmcargs=setenv bootargs root=${rootdev} rw rootwait\0"		\
	"nfsargs="							\
		"setenv bootargs root=/dev/nfs rw "			\
			"nfsroot=${serverip}:${rootpath},v3,tcp\0"	\
	"mmc_mmc="							\
		"run mmcload mmcargs addargs ; "			\
		"bootm ${kernel_addr_r}\0"				\
	"mmc_nfs="							\
		"run mmcload nfsargs addip addargs ; "			\
		"bootm ${kernel_addr_r}\0"				\
	"net_mmc="							\
		"run netload mmcargs addargs ; "			\
		"bootm ${kernel_addr_r}\0"				\
	"net_nfs="							\
		"run netload nfsargs addip addargs ; "			\
		"bootm ${kernel_addr_r}\0"				\
	"try_bootscript="						\
		"mmc rescan;"						\
		"if test -e mmc 0:2 ${bootscript} ; then "		\
		"if load mmc 0:2 ${kernel_addr_r} ${bootscript};"	\
		"then ; "						\
			"echo Running bootscript... ; "			\
			"source ${kernel_addr_r} ; "			\
		"fi ; "							\
		"fi\0"

/* The rest of the configuration is shared */
#include <configs/socfpga_common.h>

#endif	/* __CONFIG_DENX_MCVEVK_H__ */
Commit	Line	Data
d88995a8 MV	1	/*
	2	* Copyright (C) 2015 Marek Vasut <marex@denx.de>
	3	*
	4	* SPDX-License-Identifier: GPL-2.0+
	5	*/
	6	#ifndef __CONFIG_DENX_MCVEVK_H__
	7	#define __CONFIG_DENX_MCVEVK_H__
	8
	9	#include <asm/arch/socfpga_base_addrs.h>
	10
	11	/* U-Boot Commands */
	12	#define CONFIG_SYS_NO_FLASH
	13	#define CONFIG_DOS_PARTITION
	14	#define CONFIG_FAT_WRITE
	15	#define CONFIG_HW_WATCHDOG
	16
	17	#define CONFIG_CMD_ASKENV
	18	#define CONFIG_CMD_BOOTZ
	19	#define CONFIG_CMD_CACHE
	20	#define CONFIG_CMD_DFU
	21	#define CONFIG_CMD_DHCP
	22	#define CONFIG_CMD_EXT4
	23	#define CONFIG_CMD_EXT4_WRITE
	24	#define CONFIG_CMD_FAT
	25	#define CONFIG_CMD_FS_GENERIC
	26	#define CONFIG_CMD_GPIO
	27	#define CONFIG_CMD_GREPENV
	28	#define CONFIG_CMD_MII
	29	#define CONFIG_CMD_MMC
	30	#define CONFIG_CMD_PING
	31	#define CONFIG_CMD_USB
	32	#define CONFIG_CMD_USB_MASS_STORAGE
	33
	34	/* Memory configurations */
	35	#define PHYS_SDRAM_1_SIZE 0x40000000 /* 1GiB on MCV */
	36
	37	/* Booting Linux */
	38	#define CONFIG_BOOTDELAY 3
	39	#define CONFIG_BOOTFILE "fitImage"
	40	#define CONFIG_BOOTARGS "console=ttyS0," __stringify(CONFIG_BAUDRATE)
	41	#define CONFIG_PREBOOT "run try_bootscript"
	42	#define CONFIG_BOOTCOMMAND "run mmc_mmc"
	43	#define CONFIG_LOADADDR 0x01000000
	44	#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR
	45
68a3e32b DN	46	#define CONFIG_ENV_IS_NOWHERE
68a3e32b DN	47
d88995a8 MV	48	/* USB */
	49	#ifdef CONFIG_CMD_USB
	50	#define CONFIG_USB_DWC2_REG_ADDR SOCFPGA_USB1_ADDRESS
	51	#endif
	52	#define CONFIG_G_DNL_MANUFACTURER "DENX"
	53
	54	/* Extra Environment */
	55	#define CONFIG_HOSTNAME mcvevk
	56
	57	#define CONFIG_EXTRA_ENV_SETTINGS \
	58	"consdev=ttyS0\0" \
	59	"baudrate=115200\0" \
	60	"bootscript=boot.scr\0" \
	61	"bootdev=/dev/mmcblk0p2\0" \
	62	"rootdev=/dev/mmcblk0p3\0" \
	63	"netdev=eth0\0" \
	64	"hostname=mcvevk\0" \
	65	"kernel_addr_r=0x10000000\0" \
	66	"update_filename=u-boot-with-spl-dtb.sfp\0" \
	67	"update_sd_offset=0x800\0" \
	68	"update_sd=" /* Update the SD firmware partition */ \
	69	"if mmc rescan ; then " \
	70	"if tftp ${update_filename} ; then " \
	71	"setexpr fw_sz ${filesize} / 0x200 ; " /* SD block size */ \
	72	"setexpr fw_sz ${fw_sz} + 1 ; " \
	73	"mmc write ${loadaddr} ${update_sd_offset} ${fw_sz} ; " \
	74	"fi ; " \
	75	"fi\0" \
	76	"update_qspi_offset=0x0\0" \
	77	"update_qspi=" /* Update the QSPI firmware */ \
	78	"if sf probe ; then " \
	79	"if tftp ${update_filename} ; then " \
	80	"sf update ${loadaddr} ${update_qspi_offset} ${filesize} ; " \
	81	"fi ; " \
	82	"fi\0" \
	83	"fpga_filename=output_file.rbf\0" \
	84	"load_fpga=" /* Load FPGA bitstream */ \
	85	"if tftp ${fpga_filename} ; then " \
	86	"fpga load 0 $loadaddr $filesize ; " \
	87	"bridge enable ; " \
	88	"fi\0" \
	89	"addcons=" \
	90	"setenv bootargs ${bootargs} " \
	91	"console=${consdev},${baudrate}\0" \
	92	"addip=" \
	93	"setenv bootargs ${bootargs} " \
	94	"ip=${ipaddr}:${serverip}:${gatewayip}:" \
	95	"${netmask}:${hostname}:${netdev}:off\0" \
	96	"addmisc=" \
	97	"setenv bootargs ${bootargs} ${miscargs}\0" \
	98	"addargs=run addcons addmisc\0" \
	99	"mmcload=" \
	100	"mmc rescan ; " \
	101	"load mmc 0:2 ${kernel_addr_r} ${bootfile}\0" \
	102	"netload=" \
	103	"tftp ${kernel_addr_r} ${hostname}/${bootfile}\0" \
	104	"miscargs=nohlt panic=1\0" \
	105	"mmcargs=setenv bootargs root=${rootdev} rw rootwait\0" \
	106	"nfsargs=" \
	107	"setenv bootargs root=/dev/nfs rw " \
	108	"nfsroot=${serverip}:${rootpath},v3,tcp\0" \
	109	"mmc_mmc=" \
	110	"run mmcload mmcargs addargs ; " \
	111	"bootm ${kernel_addr_r}\0" \
112	"mmc_nfs=" \
113	"run mmcload nfsargs addip addargs ; " \
114	"bootm ${kernel_addr_r}\0" \
115	"net_mmc=" \
116	"run netload mmcargs addargs ; " \
117	"bootm ${kernel_addr_r}\0" \
118	"net_nfs=" \
119	"run netload nfsargs addip addargs ; " \
120	"bootm ${kernel_addr_r}\0" \
121	"try_bootscript=" \
122	"mmc rescan;" \
123	"if test -e mmc 0:2 ${bootscript} ; then " \
124	"if load mmc 0:2 ${kernel_addr_r} ${bootscript};" \
125	"then ; " \
126	"echo Running bootscript... ; " \
127	"source ${kernel_addr_r} ; " \
128	"fi ; " \
129	"fi\0"
130
131	/* The rest of the configuration is shared */
132	#include <configs/socfpga_common.h>
133
134	#endif /* __CONFIG_DENX_MCVEVK_H__ */