| | 1 | How to use U-Boot on Engicam i.CoreM6 DualLite/Solo and Quad/Dual Starter Kit: |
| | 2 | ----------------------------------------------------------------------------- |
| | 3 | |
| | 4 | - Configure U-Boot for Engicam i.CoreM6 QDL: |
| | 5 | |
| | 6 | $ make mrproper |
| | 7 | $ make imx6qdl_icore_mmc_defconfig |
| | 8 | |
| | 9 | - Build for i.CoreM6 DualLite/Solo |
| | 10 | |
| | 11 | $ make |
| | 12 | |
| | 13 | - Build for i.CoreM6 Quad/Dual |
| | 14 | |
| | 15 | $ make DEVICE_TREE=imx6q-icore |
| | 16 | |
| | 17 | This will generate the SPL image called SPL and the u-boot-dtb.img. |
| | 18 | |
| | 19 | - Flash the SPL image into the micro SD card: |
| | 20 | |
| | 21 | sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync |
| | 22 | |
| | 23 | - Flash the u-boot-dtb.img image into the micro SD card: |
| | 24 | |
| | 25 | sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync |
| | 26 | |
| | 27 | - Jumper settings: |
| | 28 | |
| | 29 | MMC Boot: JM3 Closed |
| | 30 | |
| | 31 | - Connect the Serial cable between the Starter Kit and the PC for the console. |
| | 32 | (J28 is the Linux Serial console connector) |
| | 33 | |
| | 34 | - Insert the micro SD card in the board, power it up and U-Boot messages should |
| | 35 | come up. |
| | 36 | |
| | 37 | - Note: For loading Linux on Quad/Dual modules set the dtb as |
| | 38 | icorem6qdl> setenv fdt_file imx6q-icore.dtb |
projects / people / ms / u-boot.git / blame_incremental