]>
Commit | Line | Data |
---|---|---|
1 | /* | |
2 | * (C) Copyright 2000-2004 | |
3 | * Wolfgang Denk, DENX Software Engineering, wd@denx.de. | |
4 | * | |
5 | * SPDX-License-Identifier: GPL-2.0+ | |
6 | */ | |
7 | ||
8 | /* | |
9 | * The purpose of this code is to signal the operational status of a | |
10 | * target which usually boots over the network; while running in | |
11 | * PCBoot, a status LED is blinking. As soon as a valid BOOTP reply | |
12 | * message has been received, the LED is turned off. The Linux | |
13 | * kernel, once it is running, will start blinking the LED again, | |
14 | * with another frequency. | |
15 | */ | |
16 | ||
17 | #ifndef _STATUS_LED_H_ | |
18 | #define _STATUS_LED_H_ | |
19 | ||
20 | #ifdef CONFIG_LED_STATUS | |
21 | ||
22 | #define LED_STATUS_PERIOD (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ) | |
23 | #ifdef CONFIG_LED_STATUS1 | |
24 | #define LED_STATUS_PERIOD1 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ1) | |
25 | #endif /* CONFIG_LED_STATUS1 */ | |
26 | #ifdef CONFIG_LED_STATUS2 | |
27 | #define LED_STATUS_PERIOD2 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ2) | |
28 | #endif /* CONFIG_LED_STATUS2 */ | |
29 | #ifdef CONFIG_LED_STATUS3 | |
30 | #define LED_STATUS_PERIOD3 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ3) | |
31 | #endif /* CONFIG_LED_STATUS3 */ | |
32 | #ifdef CONFIG_LED_STATUS4 | |
33 | #define LED_STATUS_PERIOD4 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ4) | |
34 | #endif /* CONFIG_LED_STATUS4 */ | |
35 | #ifdef CONFIG_LED_STATUS5 | |
36 | #define LED_STATUS_PERIOD5 (CONFIG_SYS_HZ / CONFIG_LED_STATUS_FREQ5) | |
37 | #endif /* CONFIG_LED_STATUS5 */ | |
38 | ||
39 | void status_led_init(void); | |
40 | void status_led_tick (unsigned long timestamp); | |
41 | void status_led_set (int led, int state); | |
42 | ||
43 | /***** TQM8xxL ********************************************************/ | |
44 | #if defined(CONFIG_TQM8xxL) | |
45 | # define STATUS_LED_PAR im_cpm.cp_pbpar | |
46 | # define STATUS_LED_DIR im_cpm.cp_pbdir | |
47 | # define STATUS_LED_ODR im_cpm.cp_pbodr | |
48 | # define STATUS_LED_DAT im_cpm.cp_pbdat | |
49 | ||
50 | # define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */ | |
51 | ||
52 | /***** MVS v1 **********************************************************/ | |
53 | #elif (defined(CONFIG_MVS) && CONFIG_MVS < 2) | |
54 | # define STATUS_LED_PAR im_ioport.iop_pdpar | |
55 | # define STATUS_LED_DIR im_ioport.iop_pddir | |
56 | # undef STATUS_LED_ODR | |
57 | # define STATUS_LED_DAT im_ioport.iop_pddat | |
58 | ||
59 | # define STATUS_LED_ACTIVE 1 /* LED on for bit == 1 */ | |
60 | ||
61 | /***** Someone else defines these *************************************/ | |
62 | #elif defined(STATUS_LED_PAR) | |
63 | /* | |
64 | * ADVICE: Define in your board configuration file rather than | |
65 | * filling this file up with lots of custom board stuff. | |
66 | */ | |
67 | ||
68 | #elif defined(CONFIG_V38B) | |
69 | ||
70 | # define STATUS_LED_ACTIVE 0 /* LED on for bit == 0 */ | |
71 | ||
72 | #elif defined(CONFIG_LED_STATUS_BOARD_SPECIFIC) | |
73 | /* led_id_t is unsigned long mask */ | |
74 | typedef unsigned long led_id_t; | |
75 | ||
76 | extern void __led_toggle (led_id_t mask); | |
77 | extern void __led_init (led_id_t mask, int state); | |
78 | extern void __led_set (led_id_t mask, int state); | |
79 | void __led_blink(led_id_t mask, int freq); | |
80 | #else | |
81 | # error Status LED configuration missing | |
82 | #endif | |
83 | /************************************************************************/ | |
84 | ||
85 | #ifndef CONFIG_LED_STATUS_BOARD_SPECIFIC | |
86 | # include <asm/status_led.h> | |
87 | #endif | |
88 | ||
89 | #endif /* CONFIG_LED_STATUS */ | |
90 | ||
91 | /* | |
92 | * Coloured LEDs API | |
93 | */ | |
94 | #ifndef __ASSEMBLY__ | |
95 | void coloured_LED_init(void); | |
96 | void red_led_on(void); | |
97 | void red_led_off(void); | |
98 | void green_led_on(void); | |
99 | void green_led_off(void); | |
100 | void yellow_led_on(void); | |
101 | void yellow_led_off(void); | |
102 | void blue_led_on(void); | |
103 | void blue_led_off(void); | |
104 | #else | |
105 | .extern LED_init | |
106 | .extern red_led_on | |
107 | .extern red_led_off | |
108 | .extern yellow_led_on | |
109 | .extern yellow_led_off | |
110 | .extern green_led_on | |
111 | .extern green_led_off | |
112 | .extern blue_led_on | |
113 | .extern blue_led_off | |
114 | #endif | |
115 | ||
116 | #endif /* _STATUS_LED_H_ */ |