]> git.ipfire.org Git - people/ms/u-boot.git/blob - board/amcc/yosemite/init.S
drivers, block: remove sil680 driver
[people/ms/u-boot.git] / board / amcc / yosemite / init.S
1 /*
2 * SPDX-License-Identifier: GPL-2.0+
3 */
4
5 #include <asm-offsets.h>
6 #include <ppc_asm.tmpl>
7 #include <asm/mmu.h>
8 #include <config.h>
9
10 /**************************************************************************
11 * TLB TABLE
12 *
13 * This table is used by the cpu boot code to setup the initial tlb
14 * entries. Rather than make broad assumptions in the cpu source tree,
15 * this table lets each board set things up however they like.
16 *
17 * Pointer to the table is returned in r1
18 *
19 *************************************************************************/
20
21 .section .bootpg,"ax"
22 .globl tlbtab
23
24 tlbtab:
25 tlbtab_start
26
27 /*
28 * BOOT_CS (FLASH) must be first. Before relocation SA_I can be off to use the
29 * speed up boot process. It is patched after relocation to enable SA_I
30 */
31 tlbentry( CONFIG_SYS_BOOT_BASE_ADDR, SZ_256M, CONFIG_SYS_BOOT_BASE_ADDR, 0, AC_RWX | SA_G/*|SA_I*/)
32
33 /* TLB-entry for init-ram in dcache (SA_I must be turned off!) */
34 tlbentry( CONFIG_SYS_INIT_RAM_ADDR, SZ_64K, CONFIG_SYS_INIT_RAM_ADDR, 0, AC_RWX | SA_G )
35
36 tlbentry( CONFIG_SYS_SDRAM_BASE, SZ_256M, CONFIG_SYS_SDRAM_BASE, 0, AC_RWX | SA_IG )
37 tlbentry( CONFIG_SYS_PCI_BASE, SZ_256M, CONFIG_SYS_PCI_BASE, 0, AC_RW | SA_IG )
38 tlbentry( CONFIG_SYS_NVRAM_BASE_ADDR, SZ_256M, CONFIG_SYS_NVRAM_BASE_ADDR, 0, AC_RWX | SA_W|SA_I )
39
40 /* PCI */
41 tlbentry( CONFIG_SYS_PCI_MEMBASE, SZ_256M, CONFIG_SYS_PCI_MEMBASE, 0, AC_RW | SA_IG )
42 tlbentry( CONFIG_SYS_PCI_MEMBASE1, SZ_256M, CONFIG_SYS_PCI_MEMBASE1, 0, AC_RW | SA_IG )
43 tlbentry( CONFIG_SYS_PCI_MEMBASE2, SZ_256M, CONFIG_SYS_PCI_MEMBASE2, 0, AC_RW | SA_IG )
44 tlbentry( CONFIG_SYS_PCI_MEMBASE3, SZ_256M, CONFIG_SYS_PCI_MEMBASE3, 0, AC_RW | SA_IG )
45
46 /* USB 2.0 Device */
47 tlbentry( CONFIG_SYS_USB_DEVICE, SZ_1K, 0x50000000, 0, AC_RW | SA_IG )
48
49 tlbtab_end