drivers/bootcount/Kconfig

   1 #
   2 # Boot count configuration
   3 #
   4
   5 menuconfig BOOTCOUNT_LIMIT
   6         bool "Enable support for checking boot count limit"
   7         help
   8           Enable checking for exceeding the boot count limit.
   9           More information: http://www.denx.de/wiki/DULG/UBootBootCountLimit
  10
  11 if BOOTCOUNT_LIMIT
  12
  13 choice
  14         prompt "Boot count device"
  15         default BOOTCOUNT_AM33XX if AM33XX || SOC_DA8XX
  16
  17 config BOOTCOUNT_EXT
  18         bool "Boot counter on EXT filesystem"
  19         help
  20           Add support for maintaining boot count in a file on an EXT
  21           filesystem.
  22
  23 config BOOTCOUNT_AM33XX
  24         bool "Boot counter in AM33XX RTC IP block"
  25         depends on AM33XX || SOC_DA8XX
  26         help
  27           A bootcount driver for the RTC IP block found on many TI platforms.
  28           This requires the RTC clocks, etc, to be enabled prior to use and
  29           not all boards with this IP block on it will have the RTC in use.
  30
  31 config BOOTCOUNT_ENV
  32         bool "Boot counter in environment"
  33         help
  34           If no softreset save registers are found on the hardware
  35           "bootcount" is stored in the environment. To prevent a
  36           saveenv on all reboots, the environment variable
  37           "upgrade_available" is used. If "upgrade_available" is
  38           0, "bootcount" is always 0, if "upgrade_available" is
  39           1 "bootcount" is incremented in the environment.
  40           So the Userspace Application must set the "upgrade_available"
  41           and "bootcount" variable to 0, if a boot was successfully.
  42
  43 endchoice
  44
  45 config SYS_BOOTCOUNT_SINGLEWORD
  46         bool "Use single word to pack boot count and magic value"
  47         help
  48           This option enables packing boot count magic value and boot count
  49           into single word (32 bits).
  50
  51 config SYS_BOOTCOUNT_EXT_INTERFACE
  52         string "Interface on which to find boot counter EXT filesystem"
  53         default "mmc"
  54         depends on BOOTCOUNT_EXT
  55         help
  56           Set the interface to use when locating the filesystem to use for the
  57           boot counter.
  58
  59 config SYS_BOOTCOUNT_EXT_DEVPART
  60         string "Partition of the boot counter EXT filesystem"
  61         default "0:1"
  62         depends on BOOTCOUNT_EXT
  63         help
  64           Set the partition to use when locating the filesystem to use for the
  65           boot counter.
  66
  67 config SYS_BOOTCOUNT_EXT_NAME
  68         string "Path and filename of the EXT filesystem based boot counter"
  69         default "/boot/failures"
  70         depends on BOOTCOUNT_EXT
  71         help
  72           Set the filename and path of the file used to store the boot counter.
  73
  74 config SYS_BOOTCOUNT_ADDR
  75         hex "RAM address used for reading and writing the boot counter"
  76         default 0x7000A000
  77         depends on BOOTCOUNT_EXT
  78         help
  79           Set the address used for reading and writing the boot counter.
  80
  81 endif