ATMEL: remove old atmel_mci driver

[people/ms/u-boot.git] / README

diff --git a/README b/README
index 9d713e8f4398b9af70844ab7910c67e400817bf6..89646725a0b884c5b8b10e4262a1682478788a29 100644 (file)
--- a/README
+++ b/README
@@ -1,5 +1,5 @@
 #
-# (C) Copyright 2000 - 2011
+# (C) Copyright 2000 - 2012
 # Wolfgang Denk, DENX Software Engineering, wd@denx.de.
 #
 # See file CREDITS for list of people who contributed to this
@@ -420,6 +420,12 @@ The following options need to be configured:
                XWAY SoCs for booting from NOR flash. The U-Boot image needs to
                be swapped if a flash programmer is used.
 
+- ARM options:
+               CONFIG_SYS_EXCEPTION_VECTORS_HIGH
+
+               Select high exception vectors of the ARM core, e.g., do not
+               clear the V bit of the c1 register of CP15.
+
 - Linux Kernel Interface:
                CONFIG_CLOCKS_IN_MHZ
 
@@ -809,6 +815,7 @@ The following options need to be configured:
                                          (requires CONFIG_CMD_I2C)
                CONFIG_CMD_SETGETDCR      Support for DCR Register access
                                          (4xx only)
+               CONFIG_CMD_SF           * Read/write/erase SPI NOR flash
                CONFIG_CMD_SHA1SUM        print sha1 memory digest
                                          (requires CONFIG_CMD_MEMORY)
                CONFIG_CMD_SOURCE         "source" command Support
@@ -2191,6 +2198,25 @@ The following options need to be configured:
                allows to read/write in Dataflash via the standard
                commands cp, md...
 
+- Serial Flash support
+               CONFIG_CMD_SF
+
+               Defining this option enables SPI flash commands
+               'sf probe/read/write/erase/update'.
+
+               Usage requires an initial 'probe' to define the serial
+               flash parameters, followed by read/write/erase/update
+               commands.
+
+               The following defaults may be provided by the platform
+               to handle the common case when only a single serial
+               flash is present on the system.
+
+               CONFIG_SF_DEFAULT_BUS           Bus identifier
+               CONFIG_SF_DEFAULT_CS            Chip-select
+               CONFIG_SF_DEFAULT_MODE          (see include/spi.h)
+               CONFIG_SF_DEFAULT_SPEED         in Hz
+
 - SystemACE Support:
                CONFIG_SYSTEMACE
 
@@ -3639,6 +3665,14 @@ List of environment variables (most likely not complete):
 
   fdt_high     - if set this restricts the maximum address that the
                  flattened device tree will be copied into upon boot.
+                 For example, if you have a system with 1 GB memory
+                 at physical address 0x10000000, while Linux kernel
+                 only recognizes the first 704 MB as low memory, you
+                 may need to set fdt_high as 0x3C000000 to have the
+                 device tree blob be copied to the maximum address
+                 of the 704 MB low memory, so that Linux kernel can
+                 access it during the boot procedure.
+
                  If this is set to the special value 0xFFFFFFFF then
                  the fdt will not be copied at all on boot.  For this
                  to work it must reside in writable memory, have