*/
#include <common.h>
-#include <miiphy.h>
-#include <netdev.h>
#include <asm/io.h>
#include <asm/gpio.h>
#include <asm/arch/mx6-pins.h>
#include <asm/arch/sys_proto.h>
#include <asm/imx-common/iomux-v3.h>
+#include <asm/imx-common/video.h>
DECLARE_GLOBAL_DATA_PTR;
PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_MED | \
PAD_CTL_DSE_40ohm | PAD_CTL_SRE_FAST | PAD_CTL_HYS)
-#define ENET_PAD_CTRL (PAD_CTL_PKE | PAD_CTL_PUE | \
- PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_MED | \
- PAD_CTL_DSE_40ohm | PAD_CTL_HYS)
-
static iomux_v3_cfg_t const uart4_pads[] = {
IOMUX_PADS(PAD_KEY_COL0__UART4_TX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL)),
IOMUX_PADS(PAD_KEY_ROW0__UART4_RX_DATA | MUX_PAD_CTRL(UART_PAD_CTRL)),
};
-static iomux_v3_cfg_t const enet_pads[] = {
- IOMUX_PADS(PAD_ENET_CRS_DV__ENET_RX_EN | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_GPIO_16__ENET_REF_CLK | MUX_PAD_CTRL(ENET_PAD_CTRL | PAD_CTL_SRE_FAST)),
- IOMUX_PADS(PAD_ENET_TX_EN__ENET_TX_EN | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_ENET_RXD1__ENET_RX_DATA1 | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_ENET_RXD0__ENET_RX_DATA0 | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_ENET_TXD1__ENET_TX_DATA1 | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_ENET_TXD0__ENET_TX_DATA0 | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_ENET_MDC__ENET_MDC | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_ENET_MDIO__ENET_MDIO | MUX_PAD_CTRL(ENET_PAD_CTRL)),
- IOMUX_PADS(PAD_GPIO_17__GPIO7_IO12 | MUX_PAD_CTRL(NO_PAD_CTRL)),
-};
-
-#ifdef CONFIG_FEC_MXC
-#define ENET_PHY_RST IMX_GPIO_NR(7, 12)
-static int setup_fec(void)
-{
- struct mxc_ccm_reg *ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
- struct anatop_regs *anatop = (struct anatop_regs *)ANATOP_BASE_ADDR;
- s32 timeout = 100000;
- u32 reg = 0;
- int ret;
-
- /* Enable fec clock */
- setbits_le32(&ccm->CCGR1, MXC_CCM_CCGR1_ENET_MASK);
-
- /* use 50MHz */
- ret = enable_fec_anatop_clock(0, ENET_50MHZ);
- if (ret)
- return ret;
-
- /* Enable PLLs */
- reg = readl(&anatop->pll_enet);
- reg &= ~BM_ANADIG_PLL_SYS_POWERDOWN;
- writel(reg, &anatop->pll_enet);
- reg = readl(&anatop->pll_enet);
- reg |= BM_ANADIG_PLL_SYS_ENABLE;
- while (timeout--) {
- if (readl(&anatop->pll_enet) & BM_ANADIG_PLL_SYS_LOCK)
- break;
- }
- if (timeout <= 0)
- return -EIO;
- reg &= ~BM_ANADIG_PLL_SYS_BYPASS;
- writel(reg, &anatop->pll_enet);
-
- /* reset the phy */
- gpio_direction_output(ENET_PHY_RST, 0);
- udelay(10000);
- gpio_set_value(ENET_PHY_RST, 1);
-
- return 0;
-}
-
-int board_eth_init(bd_t *bis)
-{
- int ret;
-
- SETUP_IOMUX_PADS(enet_pads);
- setup_fec();
-
- return ret = cpu_eth_init(bis);
-}
-#endif
-
#ifdef CONFIG_NAND_MXS
#define GPMI_PAD_CTRL0 (PAD_CTL_PKE | PAD_CTL_PUE | PAD_CTL_PUS_100K_UP)
}
#endif
+#if defined(CONFIG_VIDEO_IPUV3)
+static iomux_v3_cfg_t const rgb_pads[] = {
+ IOMUX_PADS(PAD_DI0_DISP_CLK__IPU1_DI0_DISP_CLK),
+ IOMUX_PADS(PAD_DI0_PIN15__IPU1_DI0_PIN15),
+ IOMUX_PADS(PAD_DI0_PIN2__IPU1_DI0_PIN02),
+ IOMUX_PADS(PAD_DI0_PIN3__IPU1_DI0_PIN03),
+ IOMUX_PADS(PAD_DISP0_DAT0__IPU1_DISP0_DATA00),
+ IOMUX_PADS(PAD_DISP0_DAT1__IPU1_DISP0_DATA01),
+ IOMUX_PADS(PAD_DISP0_DAT2__IPU1_DISP0_DATA02),
+ IOMUX_PADS(PAD_DISP0_DAT3__IPU1_DISP0_DATA03),
+ IOMUX_PADS(PAD_DISP0_DAT4__IPU1_DISP0_DATA04),
+ IOMUX_PADS(PAD_DISP0_DAT5__IPU1_DISP0_DATA05),
+ IOMUX_PADS(PAD_DISP0_DAT6__IPU1_DISP0_DATA06),
+ IOMUX_PADS(PAD_DISP0_DAT7__IPU1_DISP0_DATA07),
+ IOMUX_PADS(PAD_DISP0_DAT8__IPU1_DISP0_DATA08),
+ IOMUX_PADS(PAD_DISP0_DAT9__IPU1_DISP0_DATA09),
+ IOMUX_PADS(PAD_DISP0_DAT10__IPU1_DISP0_DATA10),
+ IOMUX_PADS(PAD_DISP0_DAT11__IPU1_DISP0_DATA11),
+ IOMUX_PADS(PAD_DISP0_DAT12__IPU1_DISP0_DATA12),
+ IOMUX_PADS(PAD_DISP0_DAT13__IPU1_DISP0_DATA13),
+ IOMUX_PADS(PAD_DISP0_DAT14__IPU1_DISP0_DATA14),
+ IOMUX_PADS(PAD_DISP0_DAT15__IPU1_DISP0_DATA15),
+ IOMUX_PADS(PAD_DISP0_DAT16__IPU1_DISP0_DATA16),
+ IOMUX_PADS(PAD_DISP0_DAT17__IPU1_DISP0_DATA17),
+};
+
+static void enable_rgb(struct display_info_t const *dev)
+{
+ SETUP_IOMUX_PADS(rgb_pads);
+}
+
+struct display_info_t const displays[] = {
+ {
+ .bus = -1,
+ .addr = 0,
+ .pixfmt = IPU_PIX_FMT_RGB666,
+ .detect = NULL,
+ .enable = enable_rgb,
+ .mode = {
+ .name = "Amp-WD",
+ .refresh = 60,
+ .xres = 800,
+ .yres = 480,
+ .pixclock = 30000,
+ .left_margin = 30,
+ .right_margin = 30,
+ .upper_margin = 5,
+ .lower_margin = 5,
+ .hsync_len = 64,
+ .vsync_len = 20,
+ .sync = FB_SYNC_EXT,
+ .vmode = FB_VMODE_NONINTERLACED
+ }
+ },
+};
+
+size_t display_count = ARRAY_SIZE(displays);
+
+static void setup_display(void)
+{
+ struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
+ struct iomuxc *iomux = (struct iomuxc *)IOMUXC_BASE_ADDR;
+ int reg;
+
+ enable_ipu_clock();
+
+ /* Turn on LDB0,IPU,IPU DI0 clocks */
+ reg = __raw_readl(&mxc_ccm->CCGR3);
+ reg |= (MXC_CCM_CCGR3_LDB_DI0_MASK | 0xffff);
+ writel(reg, &mxc_ccm->CCGR3);
+
+ /* set LDB0, LDB1 clk select to 011/011 */
+ reg = readl(&mxc_ccm->cs2cdr);
+ reg &= ~(MXC_CCM_CS2CDR_LDB_DI0_CLK_SEL_MASK |
+ MXC_CCM_CS2CDR_LDB_DI1_CLK_SEL_MASK);
+ reg |= (3 << MXC_CCM_CS2CDR_LDB_DI0_CLK_SEL_OFFSET) |
+ (3 << MXC_CCM_CS2CDR_LDB_DI1_CLK_SEL_OFFSET);
+ writel(reg, &mxc_ccm->cs2cdr);
+
+ reg = readl(&mxc_ccm->cscmr2);
+ reg |= MXC_CCM_CSCMR2_LDB_DI0_IPU_DIV;
+ writel(reg, &mxc_ccm->cscmr2);
+
+ reg = readl(&mxc_ccm->chsccdr);
+ reg |= (CHSCCDR_CLK_SEL_LDB_DI0 <<
+ MXC_CCM_CHSCCDR_IPU1_DI0_CLK_SEL_OFFSET);
+ writel(reg, &mxc_ccm->chsccdr);
+
+ reg = IOMUXC_GPR2_BGREF_RRMODE_EXTERNAL_RES |
+ IOMUXC_GPR2_DI1_VS_POLARITY_ACTIVE_HIGH |
+ IOMUXC_GPR2_DI0_VS_POLARITY_ACTIVE_LOW |
+ IOMUXC_GPR2_BIT_MAPPING_CH1_SPWG |
+ IOMUXC_GPR2_DATA_WIDTH_CH1_18BIT |
+ IOMUXC_GPR2_BIT_MAPPING_CH0_SPWG |
+ IOMUXC_GPR2_DATA_WIDTH_CH0_18BIT |
+ IOMUXC_GPR2_LVDS_CH1_MODE_DISABLED |
+ IOMUXC_GPR2_LVDS_CH0_MODE_ENABLED_DI0;
+ writel(reg, &iomux->gpr[2]);
+
+ reg = readl(&iomux->gpr[3]);
+ reg = (reg & ~IOMUXC_GPR3_LVDS0_MUX_CTL_MASK) |
+ (IOMUXC_GPR3_MUX_SRC_IPU1_DI0 <<
+ IOMUXC_GPR3_LVDS0_MUX_CTL_OFFSET);
+ writel(reg, &iomux->gpr[3]);
+}
+#endif /* CONFIG_VIDEO_IPUV3 */
+
int board_early_init_f(void)
{
SETUP_IOMUX_PADS(uart4_pads);
#ifdef CONFIG_NAND_MXS
setup_gpmi_nand();
#endif
+
+#ifdef CONFIG_VIDEO_IPUV3
+ setup_display();
+#endif
+
return 0;
}
projects / people / ms / u-boot.git / blobdiff