U_BOOT_CMD(
burn_in, 1, 1, do_burn_in,
- "burn_in - start burn-in test application on TRAB\n",
+ "start burn-in test application on TRAB",
"\n"
" - start burn-in test application\n"
" The burn-in test could took a while to finish!\n"
U_BOOT_CMD(
dip, 1, 1, do_dip,
- "dip - read dip switch on TRAB\n",
+ "read dip switch on TRAB",
"\n"
" - read state of dip switch (S1) on TRAB board\n"
" read sequence: 1-2-3-4; ON=1; OFF=0; e.g.: \"0100\"\n"
U_BOOT_CMD(
vcc5v, 1, 1, do_vcc5v,
- "vcc5v - read VCC5V on TRAB\n",
+ "read VCC5V on TRAB",
"\n"
" - read actual value of voltage VCC5V\n"
);
U_BOOT_CMD(
c_temp, 1, 1, do_contact_temp,
- "c_temp - read contact temperature on TRAB\n",
+ "read contact temperature on TRAB",
"\n"
" - reads the onboard temperature (=contact temperature)\n"
);
U_BOOT_CMD(
bis, 1, 1, do_burn_in_status,
- "bis - print burn in status on TRAB\n",
+ "print burn in status on TRAB",
"\n"
" - prints the status variables of the last burn in test\n"
" stored in the onboard EEPROM on TRAB board\n"
U_BOOT_CMD(
tlog, 2, 1, do_temp_log,
- "tlog - log contact temperature [1/100 C] to console (endlessly)\n",
+ "log contact temperature [1/100 C] to console (endlessly)",
"delay\n"
" - contact temperature [1/100 C] is printed endlessly to console\n"
" <delay> specifies the seconds to wait between two measurements\n"