help
This option is used to set the default fdt file to boot OS.
-config SYS_NO_FLASH
- bool "Disable support for parallel NOR flash"
- default n
- help
- This option is used to disable support for parallel NOR flash.
-
config VERSION_VARIABLE
bool "add U-Boot environment variable vers"
default n
config DISPLAY_CPUINFO
bool "Display information about the CPU during start up"
- default y if ARM || BLACKFIN || NIOS2 || X86 || XTENSA
+ default y if ARM || BLACKFIN || NIOS2 || X86 || XTENSA || MPC5xxx
help
Display information about the CPU that U-Boot is running on
when U-Boot starts up. The function print_cpuinfo() is called
when U-Boot starts up. The board function checkboard() is called
to do this.
+menu "Start-up hooks"
+
+config ARCH_EARLY_INIT_R
+ bool "Call arch-specific init soon after relocation"
+ default y if X86
+ help
+ With this option U-Boot will call arch_early_init_r() soon after
+ relocation. Driver model is running by this point, and the cache
+ is on. Note that board_early_init_r() is called first, if
+ enabled. This can be used to set up architecture-specific devices.
+
+config ARCH_MISC_INIT
+ bool "Call arch-specific init after relocation, when console is ready"
+ help
+ With this option U-Boot will call arch_misc_init() after
+ relocation to allow miscellaneous arch-dependent initialisation
+ to be performed. This function should be defined by the board
+ and will be called after the console is set up, after relocaiton.
+
+config BOARD_EARLY_INIT_F
+ bool "Call board-specific init before relocation"
+ default y if X86
+ help
+ Some boards need to perform initialisation as soon as possible
+ after boot. With this option, U-Boot calls board_early_init_f()
+ after driver model is ready in the pre-relocation init sequence.
+ Note that the normal serial console is not yet set up, but the
+ debug UART will be available if enabled.
+
+endmenu
+
source "common/spl/Kconfig"